Netgear M5300-52G Command Line Interface (CLI) User Manual - Page 415
trapflags OSPFv3, group name
View all Netgear M5300-52G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 415 highlights
ProSafe Managed Switch trapflags (OSPFv3) Use this command to enable individual OSPF traps, enable a group of trap flags at a time, or enable all the trap flags at a time. The different groups of trapflags, and each group's specific trapflags to enable or disable, are listed in Table 2, Trapflag Groups (OSPFv3). Table 2. Trapflag Groups (OSPFv3) Group errors if-rx lsa overflow retransmit rtb state-change Flags • authentication-failure • bad-packet • config-error • virt-authentication-failure • virt-bad-packet • virt-config-error ir-rx-packet • lsa-maxage • lsa-originate • lsdb-overflow • lsdb-approaching-overflow • packets • virt-packets • rtb-entry-info • if-state-change • neighbor-state-change • virtif-state-change • virtneighbor-state-change • To enable the individual flag, enter the group name followed by that particular flag. • To enable all the flags in that group, give the group name followed by all. IPv6 Commands 415