Netgear M5300-52G Command Line Interface (CLI) User Manual - Page 743

ProSafe Managed Switch Technologies Table 54. System General Error Messages Component OS OS OS OS OS OS OS OS OS OS OS OS OS OS Message Cause Invalid USP unit = x, slot = x, port =x A port was not able to be translated correctly during the receive. In hapiBroadSystemMacAddress call to 'bcm_l2_addr_add' - FAILED : x Failed to add an L2 address to the MAC table. This should only happen when a hash collision occurs or the table is full. Failed installing mirror action - rest of the policy applied successfully A previously configured probe port is not being used in the policy. The release notes state that only a single probe port can be configured Policy x does not contain rule x The rule was not added to the policy due to a discrepancy in the rule count for this specific policy . Additionally, the message can be displayed when an old rule is being modified, but the old rule is not in the policy ERROR: policy x, tmpPolicy x, size x, data An issue installing the policy due to a x x x x x x x x possible duplicate hash ACL x not found in internal table Attempting to delete a non-existent ACL ACL internal table overflow Attempting to add an ACL to a full table In hapiBroadQosCosQueueConfig, Failed Attempting to configure the bandwidth to configure minimum bandwidth. Available beyond it's capabilities bandwidth x USL: failed to put sync response on queue A response to a sync request was not enqueued. This could indicate that a previous sync request was received after it was timed out USL: failed to sync ipmc table on unit=x Either the transport failed or the message was dropped usl_task_ipmc_msg_send(): failed to send Either the transport failed or the message with x was dropped USL: No available entries in the STG table The Spanning Tree Group table is full in USL USL: failed to sync stg table on unit=x Could not synchronize unit x due to a transport failure or API issue on remote unit. A synchronization retry will be issued USL: A Trunk doesn't exist in USL Attempting to modify a Trunk that doesn't exist Log Messages 743