Netgear M5300-52G Command Line Interface (CLI) User Manual - Page 513

ProSafe Managed Switch iscsi enable The iscsi enable Global Configuration mode command globally enables iSCSI awareness. Format Mode Default iscsi enable Global Config Disabled no iscsi enable This command is to disable iSCSI awareness use the no form of this command. When User uses this command, iSCSI resources will be released. Format Mode Default no iscsi enable Global Config Disabled iscsi target port This command configures iSCSI port/s, target addresses and names. Note: When working with private iSCSI ports (not IANA assigned iSCSI ports 3260/860), it is recommended to specify the target IP address as well, so the switch will only snoop frames with which the TCP destination port is one of the configured TCP ports, AND there destination IP is the target's IP address. This way the CPU is not be falsely loaded by non-iSCSI flows (if by chance other applications also choose to use these {un-reserved} ports). When a port is already defined and not bound to an IP, and the User wants to bind it to an IP, the User should first remove it by using the no form of the command and then add it again, this time together with the relevant IP. Target names are only for display when using show iscsi command. These names are not use to match (or for doing any sanity check) Quality of Service (QoS) Commands 513