Netgear WG602 WG602v3 User Manual - Page 42
Table 4-1., General Information Fields, This screen shows the following parameters - wg602v3 firmware
UPC - 606449030730
View all Netgear WG602 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Reference Manual for the NETGEAR 54 Mbps Wireless Access Point WG602v3 This screen shows the following parameters: Table 4-1. General Information Fields Field Access Point Information Description Access Point Name MAC Address Region Firmware Version Current IP Settings IP Address Subnet Mask Default Gateway DHCP Client Wireless Settings Wireless Network Name (SSID) Channel Encryption Type Access Control The default name can be changed if desired. Displays the Media Access Control address (MAC Addresses) of the wireless access point's Ethernet port. Displays the country or region for which the wireless access point is licensed for use. It may not be legal to operate this wireless access point in a region other than one of those identified in this field. The version of the firmware currently installed. These parameters apply to the Local WG602v3 wireless access point. The IP address of the wireless access point. The subnet mask for the wireless access point. The default gateway for the wireless access point. Enabled by default. Enabled (DHCP client) indicates that the current IP address was obtained from a DHCP server on your network. These parameters apply to the target remote WG602v3, VPN gateway, or VPN client. Displays the wireless network name (SSID) being used by the wireless port of the wireless access point. The default is NETGEAR. Identifies the channel the wireless port is using. 11 is the default channel setting. See "Wireless Channels" on page B-7 for the frequencies used on each channel. The current encryption setting. Disabled by default. 4-2 Management 202-10060-02, February 2005