Netgear WGXB102 WGX102v2 Reference Manual - Page 22
Prepare to Install Your Wireless Range Extender, Default Factory Settings - 54 mbps wall plugged wireless range extender kit
UPC - 606449036572
View all Netgear WGXB102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Reference Manual for the 54 Mbps Wall-Plugged Wireless Range Extender WGX102 Prepare to Install Your Wireless Range Extender The powerline wireless range extender kit is designed for easy installation. Check that these minimum requirements are met. • Your Ethernet network is set up with DHCP and an Ethernet port available on your router. • Your Internet connection is working. • Your wireless network is set up and you have the Network Name (SSID) and any security settings that you use (such as WEP keys). • Each computer that will use the Wireless Range Extender must have a wireless card installed and configured. Observe the wireless placement and range guidelines in "Observing Performance, Placement, and Range Guidelines" on page 5-1. Default Factory Settings When you first receive your WGX102, the default factory settings are shown below. You can restore these defaults with the factory default reset button on the bottom of the unit. FEATURE IP Address Default type Default address Mode Wireless Wireless Access List (MAC Filtering) SSID broadcast SSID 802.11b/g RF Channel Wireless Mode Authentication Type WEP and WPA-PSK DEFAULT FACTORY SETTINGS Fixed (static) 192.168.0.101 Access Point All wireless stations allowed Enabled NETGEAR 11 g and b Automatic Disabled Use the procedures below to customize any of the settings to better meet your networking needs. 3-2 Installing the Wireless Range Extender 202-10042-02 v1.1