Netgear WNDR3400v2 WNDR3400 User Manual - Page 5

v1.0, August 2010

v

FCC Guidelines for Human Exposure

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment

should be installed and operated with minimum distance of 20 cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC Declaration Of Conformity

We NETGEAR, Inc., 350 East Plumeria Drive, San Jose, CA 95134, declare under our sole responsibility that the model

WNDR3400 N600 Wireless Dual Band Router WNDR3400 complies with Part 15 of FCC Rules. Operation is subject to

the following two conditions:

•

This device may not cause harmful interference, and

•

This device must accept any interference received, including interference that may cause undesired operation.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

methods:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and the receiver.

•

Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

•

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s

authority to operate this equipment.

•

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

•

For product available in the USA market, only channel 1~11 can be operated. Selection of other channels is not

possible.

•

This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or

transmitter.

Country Code Statement

For products available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not

possible.

This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.

Section	Page
N600 Wireless Dual Band Router WNDR3400 User Manual	1
Contents	8
About This Manual	12
Chapter 1 Configuring Your Internet Connection	14
Using the Setup Manual	14
Logging In to Your Wireless Router	15
Selecting a Language for Your Screen Display	17
Using the Setup Wizard	19
Viewing or Manually Configuring Your ISP Settings	19
Chapter 2 Safeguarding Your Network	23
Planning Your Wireless Network	23
Wireless Placement and Range Guidelines	24
Wireless Security Options	25
Manually Configuring Your Wireless Settings	26
Configuring WEP Wireless Security	30
Configuring WPA, WPA2, or WPA/WPA2 Wireless Security	32
Using Push 'N' Connect (WPS) to Configure Your Wireless Network	33
Using a WPS Button to Add a WPS Client	34
Using PIN Entry to Add a WPS Client	36
Configuring Advanced WPS Settings	38
Connecting Additional Wireless Client Devices After WPS Setup	39
Adding More WPS Clients	39
Adding Both WPS and Non-WPS Clients	40
Restricting Access to Your Router	41
Adding Guest Networks	42
Chapter 3 Protecting Your Network	45
Protecting Access to Your Wireless Router	45
Changing the Built-In Password	46
Restricting Access by MAC Address	46
Blocking Access to Internet Sites	48
Blocking Access to Internet Services	49
Configuring a User-Defined Service	51
Scheduling Blocking	52
Viewing Logs of Web Access or Attempted Web Access	52
Configuring E-mail Alert and Web Access Log Notifications	53
Setting the Time	55
Chapter 4 Using Network Monitoring Tools	56
Upgrading the Router Firmware	56
Upgrading Automatically to New Router Software	58
Upgrading Manually to New Router Software	58
Viewing Wireless Router Status Information	60
Connection Status	63
Statistics	64
Viewing a List of Attached Devices	65
Managing the Configuration File	66
Backing Up and Restoring the Configuration	66
Erasing the Configuration	67
Enabling Remote Management Access	68
Scheduling Wireless Signal Down Time	69
Traffic Meter	71
Chapter 5 Customizing Your Network Settings	73
Using the LAN Setup Options	73
Using the Router as a DHCP Server	76
Address Reservation	76
Using a Dynamic DNS Service	77
Configuring the WAN Setup Options	79
Setting Up a Default DMZ Server	80
Configuring Static Routes	81
Allowing Inbound Connections to Your Network	83
How Your Computer Accesses a Remote Computer through Your Router	83
How Port Triggering Changes the Communication Process	85
How Port Forwarding Changes the Communication Process	86
How Port Forwarding Differs from Port Triggering	87
Configuring Port Forwarding to Local Servers	88
Adding a Custom Service	89
Editing or Deleting a Port Forwarding Entry	90
Configuring Port Triggering	90
Wireless Repeating (Also Called WDS)	94
Wireless Repeating Function	95
Setting Up the Base Station	96
Setting Up a Repeater Unit	98
Chapter 6 Fine-Tuning Your Network	99
Assessing Your Speed Requirements	100
Optimizing Your Network Bandwidth	101
Optimizing Wireless Performance	103
Changing the MTU Size	104
Quality of Service (QoS)	105
Using WMM QoS for Wireless Multimedia Applications	106
Configuring QoS for Internet Access	106
Universal Plug and Play	111
Chapter 7 USB Storage	113
USB Drive Requirements	113
File Sharing Scenarios	114
USB Storage Basic Settings	116
Editing a Network Folder	118
Configuring USB Storage Advanced Settings	119
Creating a Network Folder	121
ReadyShare Access	122
Unmounting a USB Drive	122
Specifying Approved USB Devices	123
Connecting to the USB Drive from a Remote Computer	124
Locating the Internet Port IP Address	124
Accessing the Router’s USB Drive Remotely Using FTP	124
Connecting to the USB Drive with Microsoft Network Settings	124
Enabling File and Printer Sharing	125
Chapter 8 Troubleshooting	126
Quick Tips	126
Troubleshooting Basic Functions	128
Cannot Access the Router Main Menu	129
Cannot Access the Internet	130
Troubleshooting a Network Using the Ping Utility	131
Testing the LAN Path to Your Router	132
Testing the Path from Your Computer to a Remote Device	133
Problems with Date and Time	133
Wireless Connectivity	134
Using Your Wireless Card Setup Program	134
Setting Up and Testing Basic Wireless Connectivity	135
Restoring the Default Configuration and Password	139
Appendix A Default Configuration and Technical Specifications	140
Restoring the Default Factory Configuration Settings	140
Technical Specifications	142
Appendix B Related Documents	144

Netgear WNDR3400v2 WNDR3400 User Manual - Page 5

FCC Guidelines for Human Exposure, FCC Declaration Of Conformity - install instructions

Page 5 highlights