Netgear WNR834M WNR834M Reference Manual - Page 24
Default Factory Settings, If WPA-PSK or WPA2-PSK Authentication is Used, Passphrase - wireless router
UPC - 606449047950
View all Netgear WNR834M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
NETGEAR RangeMax™ NEXT Wireless Router WNR834M Reference Manual Key 3 Key 4 • If WPA-PSK or WPA2-PSK Authentication is Used: - Passphrase These characters are case sensitive. Enter a word or group of printable characters. When you use WPA-PSK, the other devices in the network will not connect unless they are set to WPA-PSK as well and are configured with the correct Passphrase. Similarly, when you use WPA2-PSK, the other devices in the network will not connect unless they are also set to WPA2-PSK and are configured with the correct Passphrase. Use the procedures described in the following sections to configure the WNR834M. Store this information in a safe place. Default Factory Settings When you first receive your WNR834M, the default factory settings are in effect, as shown below. You can restore these defaults with the Factory Default Restore button on the rear panel. After you install the WNR834M router, use the procedures below to customize any of the settings to better meet your networking needs. FEATURE Wireless Router Radio Wireless Access List (MAC Filtering) SSID broadcast SSID 802.11b/g RF Channel Mode Security DEFAULT FACTORY SETTINGS Enabled All wireless stations allowed Enabled NETGEAR Auto Up to 300 Mbps None 3-4 Wireless Configuration v1.3, May 2006