Nextar SNAP3 SNAP3 Hardware Manual - Page 37
Use of the Mount, Accessories
UPC - 714129939119
View all Nextar SNAP3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Use of the Mount Accessories When using the unit in vehicle, you can use the supplied mount accessories (mount bracket, mount cradle, and dashboard mount disk) to mount the unit in the vehicle. Take the following steps to operate: Fig. 1 Fig. 2 Fig. 3 Fig. 4 1. See Fig. 1. Open the two brackets of the mount cradle as shown by the arrows. 2. See Fig. 2. First, follow the arrows 1 to set the bottom edge of the unit onto the mount cradle. Then push the mount cradle in arrow 2 direction to embed it in the unit. 3. See Fig. 3. As shown by the arrow 3, slide the mount cradle to fix it to the mount bracket. 4. See Fig. 4. Lift the suction cup lever and then press the suction cup to the windshield. Follow direction of arrow 4 to press down the suction cup lever. Then rotate the knob 5 to adjust the unit to the proper position. To mount to dashboard, use the included adhesive disk. Choose a clean, dry spot on your dashboard, peel off the protection liner from the back of the disk, and then attach the disk to your dashboard. Warning: The device must not be mounted so that it impairs the driver's view of the road. Please take extra precaution to ensure the airbags are not obstructed by the device. 36