Nikon F80QD User Manual - Page 11
Load Film
UPC - 718122227020
View all Nikon F80QD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
BASIC OPERATION Load Film 3 Turn the power switch on and load DX-coded film. With DXcoded film, film speed will be set DX-coded film automatically (ISO 25-5000). When the camera is turned on, film is loaded and the camera ISO (film speed) back is closed, the film automatically advances to the DX mark first frame. 3.1 Turn the power switch on, confirm that the film speed setting is set to s, then open the camera back by sliding the camera back lock release lever. Check points To change film speed with DX-coded film or select film advance mode, see pages 36-37. Shutter curtains are very thin. Do not touch the shutter curtains with your finger or the film leader. Avoid direct sunlight when changing film outdoors. 3.3 Hold the film cartridge and ensure film is properly positioned with no slack, then gently close the camera back until the camera back snaps closed. Film automatically advances to the first frame. • If the film speed setting is not set to s, see page 36. 3.2 Insert film from the bottom side and pull film leader out to red index mark. • Do not insert the film leader beyond the red index mark. NOTE: Loading/removing film Shutter curtains are very thin. Do not touch the shutter curtains with your finger or the film leader. 20 3.4 • When 1 appears on the LCD panel, the film has advanced to the first frame. • When Err and E blink in the LCD panel and viewfinder, film is not properly installed. Open the camera back again and reload film. • s and Err in the LCD panel and Err in viewfinder blink and the shutter locks when a non-DX-coded film is loaded with camera film speed set to s. Set film speed manually (page 36). • Frame number display remains when the power switch is off. • You can check the number of available exposures on the film roll through the film cartridge confirmation window. • Infrared films cannot be used since an infrared sensor is used for the detection of the film frame position. c 8: Camera can be set to advance the film to the first frame not until the shutter release button is pressed (page 72). Set the film advance mode selector to ı (singleframe shooting) while pressing the film advance mode selector lock release. 21