NordicTrack E 7.5 Z Elliptical English Manual - Page 11

9. Apply grease to one of the Pedal Arm Axles (64). 9 Next, insert the Pedal Arm Axle (64) into the Right Upper Body Leg (60) and the Right Pedal Arm (58) from the direction shown. Slide an M8 x 22mm Washer (129) onto an M8 x 13mm Screw (82), and tighten the Screw a few turns into the Pedal Arm Axle (64). Then, tighten both M8 x 13mm Screws (82) at the same time. Repeat this step on the other side of the elliptical. 82 129 60 64 Grease 58 82 10. Untie and discard the wire tie on the Upper Wire (110). While a second person holds the Console (7) near the Upright (4), plug the Upper Wire (110) and the Pulse Wire (63) into the receptacles on the Console. The connectors on the Wires (110, 63) should slide easily into the receptacles and snap into place. If a connector does not slide easily into a receptacle, turn the connector and try again. If you do not connect the connectors properly, the Console (7) may become damaged when you use the elliptical. Insert the excess wire into the Upright (4) or into the Console (7). Tip: Avoid pinching the wires. Attach the Console (7) to the Upright (4) with four M4 x 16mm Screws (101); start all the Screws, and then tighten them. 10 7 Avoid pinching the wires 110 4 101 63 101 11