NordicTrack Elite 7500 Treadmill English Manual - Page 26

6. Scan and save channels. Select CATV or AIR. Select CATV to receive channels through the 75 ohm terminal on the treadmill. Select AIR to receive channels through an antenna. To scan for available channels, highlight AUTO SCAN or AUTO SCAN ADD CH. To scan all channels, select the Auto scan option. To scan all channels and add an extra channel, select the Auto Scan Add Ch option. The scan channel submenu will appear. If you are receiving channels through a CATV cable, highlight CABLE SYSTEM and select the auto, STD, IRC, or HRC setting. Try all four cable settings, if necessary, to find the optimal setting. Cable System Start to Scan AUTO UP/DOWN ADJUST "MENU": EXIT Highlight START TO SCAN and press the Volume increase button to start the auto scan. The television will begin scanning all of the channels available in your area. When no signal is detected on a channel, the channel will be skipped. When a signal is detected, the channel will be saved into memory and the next channel will be selected. This process will continue until the highest channel is reached. The television will renumber the channels in the order in which it locates them. Do not remove the key while the television is scanning channels. Note: If a television channel disappears, scan for channels again. After all valid chan- nels available in your area have been saved into the televisionʼs memory, you No. Program Name Skip 4-1 FD 3803 Off 9-2 KQUED-SD Off can manually skip unwanted channels. "ENTER": SELECT "MENU": EXIT To skip a channel, highlight CHANNEL SKIP and press the Volume increase button on your remote control. In the channel skip submenu, press the Channel increase and decrease buttons to highlight the desired channel and the Volume in- crease and decrease buttons to turn on or turn off the skip option. Continue this process until you have skipped all unwanted channels. To change the dis- play name of a channel, highlight CHANNEL NO. and select a channel. Then, highlight FD 380 3 CHANNEL LABEL EDIT SELECT "MENU": EXIT and press the 456 Volume increase button to enter the channel label submenu. Press the Volume increase and decrease buttons to se- lect a number or letter box. Then press the Channel increase and decrease buttons to select the desired number or letter. 7. Exit the Menu. When you have finished adjusting the settings, press the Exit button. 26