NordicTrack Ellipse E7 English Manual - Page 10

Assemble the Arm Exerciser Assemble the Console a WARNING) Keep your hands free of the arm-exerciser pivot point. • Holding the console above the upright tube, slide the electronic cable (at the top of the upright • Snap one retaining clip onto the arm axle, then slide a washer onto the axle. tube) through the hole in the console. • Lower the console onto the upright tube. • Slide the right arm onto the axle with the handle angled forward. • Slide the axle through the upright tube. • Slide the left arm onto the axle with the handle Secure the console with the three carriage bolts and nuts. • Attach the computer as described in the instructions accompanying it. angled forward. Carriage • Slide a washer onto the axle. If there is extra clearance and space on the axle between the bolt . Electronic cable washer and groove for the retaining clip, install an optional washer next to the left-side washer. r . Electric cable • Snap a retaining clip into place using the hole side of the flat wrench. • If there is still too much space on the axle, Console remove the right side retaining clip and install 4 another washer. Nut • Snap the retaining clip back into place using the side of the flat wrench. Retaining clip. Washer. IN" Washer... . Arm Fiat wrench Retaining clip. Washer Optional Washer Optional Washer.... Axle Right arm Upright tube I Axle Retaining clip G Actual size assembly bolt 9 Left arm' Q