NordicTrack S 1900 Treadmill English Manual - Page 14

7 Measure your heart rate if desired. Note: If you use the handgrip Contacts pulse sensor and the chest pulse sensor at the same time, the console will not display your heart rate accu- rately. Before using the hand- grip pulse sen- sor, remove the sheets of clear plastic from the metal contacts. In addition, make sure that your hands are clean. To use the handgrip pulse sensor, stand on the foot rails and place your hands on the metal contacts on the handgrip pulse sensor. Your palms should be resting on the upper contacts, and your fingertips should be touching the lower contacts. Avoid moving your hands. When your pulse is detected, two dashes (- -) will appear in the Pulse/Pace display, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds. 8 When you are finished exercising, remove the key from the console. Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when the treadmill is folded to the storage position or the treadmill will be damaged. Next, remove the key from the console and put it in a secure place. Note: If the displays and various indicators on the console remain lit after the key is removed, the console is in the "demo" mode. See page 26 and turn off the demo mode. When you are finished using the treadmill, move the reset/off circuit breaker to the off position and unplug the power cord. 14