NordicTrack S 1900 Treadmill English Manual - Page 7
Properly, The Console May Be Damaged
View all NordicTrack S 1900 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
2. Slide the Right Upright (95) onto the bracket on the Base (99); be careful not to pinch the Wire Harness (39). 2 Finger tighten four Upright Bolts (86) with two 3/8" Star Washers (88) into the Right Upright and the bracket. Do not tighten the Upright Bolts yet. 39 Repeat this step with the Left Upright (not shown). Note: There is not a wire harness on the left side. 95 88 86 3. Attach the Latch Housing (89) to the Left Upright (90) 3 with two Latch Bolts (77). Do not overtighten the Latch Bolts. 89 77 86 99 90 4. Remove the elastic band securing the Wire Harness (39). Have two persons hold the console assembly near the Left Upright (90) and the Right Upright (95). Connect the Wire Harness (A) to the console wire. Make sure to connect the connectors properly (see the inset drawing); the connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the Wire Harnesses (A, 39) into the Right Upright (95). Next, insert the front ends of the brackets on the console assembly into the Right Upright and the Left Upright (90). Then, insert the back ends of the brackets into the Uprights. Make sure that the Wire Harnesses are not pinched. 4 90 7 Console Assembly Front of Bracket A 39 95 39