NordicTrack Vr23 Bike English Manual - Page 30

See Exploded Drawing A

Get NordicTrack Vr23 Bike PDF manuals and user guides View all NordicTrack Vr23 Bike manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the drive belt may need to be adjusted. To adjust the drive belt, first unplug the power adapter. See EXPLODED DRAWING B on page 35. Using an adjustable wrench, turn the Right Pedal (21) counterclockwise and remove it. See EXPLODED DRAWING A on page 34. Using a standard screwdriver, gently release the tabs on the Front Shield (58) and the Top Shield (44). Remove the Front Shield and slide the Top Shield upward. Remove all the Screws (77, 85) from the Left and Right Front Shields (13, 14); make sure to note the location of each size of Screw. Using a standard screwdriver, gently release the tabs on the right Shield Disc (52). Rotate the Shield Disc and remove it. Then, gently remove the Right Front Shield (14). Next, loosen the M6 x 20mm Hex Screw (84). Tighten the M10 x 50mm Hex Screw (83) until the Drive Belt (47) is tight. When the Drive Belt is tight, tighten the M6 x 20mm Hex Screw. 47 84 83 When the drive belt is correctly adjusted, reattach the parts that you removed. Then, plug in the power adapter. 30

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
30
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted.
To adjust the drive belt, first
unplug the power
adapter.
See EXPLODED DRAWING B on page 35.
Using
an adjustable wrench, turn the Right Pedal (21) coun-
terclockwise and remove it.
See EXPLODED DRAWING A on page 34.
Using
a standard screwdriver, gently release the tabs on the
Front Shield (58) and the Top Shield (44). Remove the
Front Shield and slide the Top Shield upward.
Remove all the Screws (77, 85) from the Left and Right
Front Shields (13, 14);
make sure to note the loca-
tion of each size of Screw.
Using a standard screwdriver, gently release the tabs
on the right Shield Disc (52). Rotate the Shield Disc
and remove it. Then, gently remove the Right Front
Shield (14).
Next, loosen the M6 x 20mm Hex Screw (84). Tighten
the M10 x 50mm Hex Screw (83) until the Drive Belt
(47) is tight. When the Drive Belt is tight, tighten the
M6 x 20mm Hex Screw.
When the drive belt is correctly adjusted, reattach
the parts that you removed. Then, plug in the power
adapter.
83
84
47