NordicTrack X22i Instruction Manual - Page 9
Attach the left Upright not shown
View all NordicTrack X22i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
4. Set the Uprights (83) on the Base (74). Make sure that the hole with the Upright Wire (75) 4 is on the right side. Attach the right Upright (83) with two of the 3/8" x 3 1/4" Screws (18) and two of the 3/8" x 2 3/4" Screws (22) that you just removed and four 3/8" Star Washers (3); do not fully tighten the Screws yet. Make sure that the Base Wire (52) is not pinched. Attach the left Upright (not shown) as described above. Note: There are no wires on the left side. Then, fully tighten the 3/8" x 3 1/4" Screws (18) and the 3/8" x 2 3/4" Screws (22). 5. Connect the Base Wire (52) to the Upright Wire (75). The connectors should slide together 5 easily and snap into place. If they do not, turn one connector and try again. Then, remove the tie (A) from the Base Wire (52), and insert the connectors into the hole (B) in the right Upright (83). 83 18 3 3 75 74 52 3 3 22 83 B A 75 52 9