Oki MICROLINE 1120 Users Guide 2 - Page 25

Oading, Continuous, Forms

Get Oki MICROLINE 1120 PDF manuals and user guides View all Oki MICROLINE 1120 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Loading continuous forms Setting up continuous forms To avoid paper feeding problems, carry out the following: 60cm 75cm 3cm 1. Check your printer is on a surface approximately 75 cm above the floor. 2. Position the continuous forms supply directly below the printer, no more than 3 cm left or right of the printer paper path. 3. Ensure the rear of the printer is close to and parallel with the edge of the surface and at least 60 cm from any wall. Feeding continuous forms 1. Ensure that the printer is turned ON. NOTE If there is a cut sheet in the printer, eject it as described in "Ejecting cut sheet paper" on page 24. 2. Set the Paper Type Lever to Continuous Forms . ML1120/ML1190 User's Guide - Paper handling > 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
ML1120/ML1190 User’s Guide - Paper handling > 25
L
OADING
CONTINUOUS
FORMS
S
ETTING
UP
CONTINUOUS
FORMS
To avoid paper feeding problems, carry out the following:
1.
Check your printer is on a surface approximately 75 cm above
the floor.
2.
Position the continuous forms supply directly below the printer,
no more than 3 cm left or right of the printer paper path.
3.
Ensure the rear of the printer is close to and parallel with the
edge of the surface and at least 60 cm from any wall.
F
EEDING
CONTINUOUS
FORMS
1.
Ensure that the printer is turned ON.
NOTE
If there is a cut sheet in the printer, eject it as described in
"Ejecting
cut sheet paper" on page 24
.
2.
Set the Paper Type Lever to Continuous Forms
.
3cm
75cm
60cm