Olympus SP 570 SP-570UZ Instruction Manual (English) - Page 40

ISO Changing the ISO sensitivity AUTO Sensitivity is automatically adjusted according to the conditions of the subject. HIGH ISO AUTO This function has a higher sensitivity compared to [AUTO] and stabilizes the blur caused by a moving subject or camera movement when taking pictures. 64/100/200/400/ 800/1600/3200/ 6400 A low value reduces the sensitivity for daylight shooting of sharp, clear pictures. The higher the value, the greater the camera's light sensitivity and ability to shoot with a fast shutter speed and in low light conditions. However, high sensitivity introduces noise into the resulting picture, which may give it a grainy appearance. • If set to [6400], [IMAGE SIZE] is limited to [H] and lower. • If [FINE ZOOM] or [DIGITAL ZOOM] is set to [ON], [6400] cannot be set. DRIVE Continuous shooting o Shoots 1 frame at a time when the shutter button is pressed. j Focus and exposure are locked at the first frame. The sequential shooting speed varies depending on the setting of image quality. c Pictures can be taken at a faster speed than normal sequential shooting. d Sequential shooting at a speed of approximately 13.5 frames/sec. • [PRE-CAPTURE] can be set. When set to [ON], pressing the shutter button halfway stores 10 frames of a picture immediately before shooting. PRE-CAPTURE OFF / ON i Adjusts the focus 1 frame at a time. The shooting speed is slower than for normal sequential shooting. BKT Takes pictures sequentially while changing the exposure for each frame (Bracket shooting). Focus and white balance are locked at the first frame. • When [BKT] is selected, the exposure differential and number of frames can be set. Exposure differential ± 0.3 / ± 0.7 / ± 1.0 Number of frames ×3 / ×5 You can take a sequence of pictures at one time by holding down the shutter button. The camera will take pictures continuously until you release the shutter button. • Only [o] is available when [IMAGE QUALITY] is set to [RAW] or [RAW+JPEG]. • When [c] or [d] is selected, other functions are restricted as follows. • The flash mode is fixed at [$]. • When [c] is selected, [IMAGE SIZE] is limited to [H] and lower and the number of pictures that can be taken continuously to approximately 30 or less (or approximately 20 or less when [H] and [L] are selected). When [d] is selected, [IMAGE SIZE] is limited to [I] and lower and the number of pictures that can be taken continuously to approximately 30 or less (including the 10 pictures when [PRE-CAPTURE] is set to [ON]). • [ISO] settings will be restricted. Menu operations 40 EN