Onkyo TX-8511 Owner Manual - Page 10
Connecting, antennas
View all Onkyo TX-8511 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Connecting antennas No/ /\ Oto. ArtnPtePnEnaP,cPaioelgesimMrir • I. Open the lever. 2. Twist wire ends very tight. and insert the wire. 3. Close the lever. et. Insert into the slot. Outdoor FWTV antenna 300 ohm ribbon wire AM loop antenna Assemble the loop antenna as shown in the illustration. (Refer to the next page for details on connecting the AM loop antenna.) 75/300 Ohm adaptor, „ (worldOde.and some other. models), , Connecting the 300 ohm ribbon wire to the 75/300 ohm adaptor Loosen the screws and wrap the wires around them. Then, tighten the screws with a screwdriver. _ elliItt1i)4; i)-- Slit B fi4-44eAi • Mill -14 -;0040 rel- Wire A Sel C errim (1) ,11 Connecting the coaxial cable to the 75/ 300 ohm adaptor I. With a small screwdriver, pull the stop- pers outwards and remove the cover. 2. Remove the transformer wire A from slit B and insert it into slit C. 3. Prepare, the coaxial cable as shown in the illustration. Connect the coaxial cable to the 75/300 ohm antenna adaptor. C) Insert the end of the cable. (i) Use pliers to pinch it and keep it in place. 4. Re-Install the cover. Directional linkage type splitter To TX-8511 To TV (or VCR) DIrectional linkage Do not use the same antenna for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can interfere with each other. If you must use a common FM/ TV (or VCR) antenna, use a directional linkage type splitter. 1'0