Onkyo TX-DS747 Owner Manual - Page 20

Setting up the multi-room remote system Using the optional Multi-Room System equipment as well as a power amplifier and connecting components as shown in the following diagrams will enable you to control them from the main room (where the system is located) as well as from another room (sub-room). U.S. and Canadian models (Xantech Multiple-Room systems) Do not plug in the power cord until all connections are made. Make connections'1" through (fi, as shown in the Connection Diagram below. Make sure the components are correctly connected. • Connecting components equipped with Onkyo R I connectors tr..41:6 MAIN ROOM 1. Onkyo Components (a) Speaker (Main room) TX-DS747 \ Speaker (Main room) N 4. Connecting Block N Power Supplyn` 2. Power Amplifier SUB-ROOM Remote Controller 5. Remote Sensor 3. Speaker (Sub-room) N 3. Speaker (Sub-room) \ I I . Set up the Onkyo RI components (a). 2. Connect the TX-DS747 to the power amplifier. (1) 3. Connect the sub-room speaker cables to the speaker terminal on the power amplifier. (,2) 4. Install the Connecting Block in the main room, then connect it to the TXDS747. 5. Install the Remote Sensor in the subroom, then connect it to the Connecting Block in the main room. A , • Connecting components not equipped with Onkyo R I connectors 11.411111hanc 3. Emitter (c) MAIN ROOM 5. Emitter (e) SUB-ROOM 4. Components (d) Connecting Block TX-DS747 \ \\. \ 1. Components (b) __ Speaker I\ -i l' Speakrer m) -(Main room (Main oo \I Power Supply 'Power Amplifier \--Remote Controller \ Speaker I (Sub-room) Remote Sensor Speaker (Sub-room) \ I I . Connect the components (h) to the TX-DS747. 2. Make the connections described above in steps 2 through 5. 3. Install the Emitter (c) so that its sensor is directed toward the components, then connect it to the TX-DS747. To operate components positioned out of range of the emitter: 4. Connect these components (d) to the TX-DS747. 5. Install another Emitter (e) so that its sensor is directed toward these components, then connect it to the Connecting Block. ('6' Connection Diagram Power Amplifier MAIN IN SPEAKERS SUB-ROOM Speakers (Sub-room) Remote Sensor O J MULTI SOURCE PRE OUT rn• IN OUT Gray Terminal Connecting Block Emitter Power Supply Speakers (Main Room) FRONT 0 SPEAKERS-A TX-DS747 20