Onkyo TX-DS747 Owner Manual - Page 21

Setting up the multi-room remote system Models other than U.S. and Canadian models (Onkyo Multi-Room systems) Do not plug in the power cord until all connections are made. Make connections ( _1) through 6j as shown in the Connection Diagram below. Make sure the components are correctly connected. • Connecting components equipped with Onkyo R I connectors MAIN ROOM 1 Onkyo Components (a) Speaker (Main room) i' \ TX-DS747 \ Speaker ' (Main room) H- SUB-ROOM Remote Controller `• 4. Remote Sensor HR-10 3. Speaker (Sub-room) 3. Speaker (Sub-room) I . Set up the Onkyo RI components (a). 2. Connect the TX-DS747 to the power amplifier. cii) 3. Connect the sub-room speaker cables to the speaker terminals on the power amplifier. (2, 4. Install Remote Sensor HR- I() in the sub-room, then connect it to the TXDS747. 2. Power Amplifier • Connecting components not equipped with Onkyo R I connectors 3. Remote Emitter HE-50 (AC) Power supply MAIN ROOM 5. Remote Emitter Head HE-10 4. Components (c) TX-DS747 N Speaker (Main room) 1. Components (b) Speaker II (Main room) H Power Amplifier SUB-ROOM Remote Controller Remote Sensor HR-10 - - Speaker \\ (Sub-room) Speaker) (Sub-room) N Connecting Diagram Power Amplifier MAIN IN am.° SPEAKERS C'Qr) SUB-ROOM Speakers (Sub-room) Remote Sensor HR-10 J tl MULTI SOURCE -.O PRE OUT nit IN OUT 'Green Terminal ++ TX-DS747 FRONT SPEAKERS A I . Connect the components (b) to the TX-DS747. 2. Make the connections described above in steps 2 through 4. 3. Install Remote Emitter HE-50 (AC) so that its sensor is directed toward these components, then connect it to the TXDS747. 4) (Connect the AC adapter to the Remote Emitter.) To operate components positioned out of range of the emitter: 4. Connect these components (c) to the TX-DS747. 5. Install Remote Emitter Head HE-10 so that its sensor is directed toward these components, then connect it to the HE50 (AC). :',5) Remote Emitter HE-50 (AC) Remo e Emitter Head HE-10 AC adapter Speakers (Main Room) 21