Onkyo TX-DS939 Owner Manual - Page 22

Setting up the Multi-Room Remote System Using the optional Multi-Room System equipment as wel l as a power amplifier and connecting a components as shown in the following diagrams makes it possible to control them from the room that they are in (main room) and from another room (sub-room). NOTE: • Do not plug in the power cord until all connections have been made. Make connections T through (6 , as shown in the connection diagram at the bottom of the page. Be sure the components are correctly connected. • Connecting components equipped with Onkyo RI connectors MAIN ROOM 1. Onkyo components (a) Speaker (Main room) N \ N TX-DS939 \, Speaker (Main room) N SUB ROOM Remote control 5. Remote sensor HR-10 3. Speaker i\) N (Sub room) 4.TV \ I 3. ▪Speaker (Sub room) 1. Set up the Onkyo RI components (a). 2. Connect the TX-DS939 to the power amplifier. („12,) 3. Connect the sub-room speaker cables to the speaker terminals on the power amplifier. (, )) 4. Connect the TX-DS939 to the TV. (3_.) 5. Install Remote Sensor HR-10 in the sub-room, then connect it to the TXDS939. (N) 2. Power amplifier • Connecting components not equipped with Onkyo RI connectors 3. Remote Emitter HE-50(AC) Power supply\ MAIN ROOM I \ 5. Remote Emitter Head HE-10 SUB ROOM 4. Components(c) TX-DS939 1. Components(b)\ Remote control Remote sensor HR-10 Speaker \ (Main room) , Speaker (Main room) I \L______4N I;Ower amplifier 'Speaker N 1 (Sub room)l TV N r\ \ Speaker (Sub room) N I Connection diagram 0 Power Amplifier I Main IN 0 0 1-OC- fl C SPEAKERS .4..t..*4... Monitor TV 1. Connect the components (b) to the TX-DS939. 2. Make the connections described above in steps 2 through 5. 3. Install Remote Emitter HE-50 (AC) so that its sensor is directed toward these components, then connect it to the TX-DS939. (',6;) (Connect the AC adaptor to the Remote Emitter.) To operate components positioned out of range of the emitter installed as described above: 4. C these comr .....unts (c) to the TX-DS939. 5. Install Remote Emitter Head HE-10 so that its sensor is directed toward these components, then connect it to the HE-50 (AC). (6)) ....... Speaker (Sub Room) SUB ROOM Remote sensor HR-10 ........... ...... . q MULTI SOURCE 1 Oe* PRE OUT 22 Speaker (Main Room) OUT FRONT SPEAKERS A MR IN - Green Terminal Remote Emitter HE-50(AC) L F• Remote Emitter Head HE-10 AC adapter L1-