Onkyo TX-DS939 Owner Manual - Page 36

Listening to your favorite source Be sure that the AUDIO MUTING indicator is not lit and that the TAPE-2 MONITOR indicator is not lit when a source other than TAPE2 MONITOR is being selected. Refer to pages 49 to 53 for more details on playing the selected source with a Surround mode. Remote control and main unit operation 3 5 0 O P o 000 2 4 1 0 O0 2 0 OO 0 7, 0 0 o C*, 0 6 1. Press either the POWER button on the remote controller or the POWER switch (SYSTEM on the European/Australian model) on the main unit to turn on the power. European/Australian model only: If the SYSTEM switch on the main unit is set to OFF, the remote controller cannot be used. 2. Press the A or B speaker selector button to select the desired speakers. The corresponding indicator (SPEAKERS A or B) lights up. 3. Press the input selector button for the desired source on the main unit or the remote controller or use the t AUDIO II. and -1 VIDEO ► buttons on the remote control. The name of the selected source wil l appear on the display. For FM or AM reception, the band and the frequency wil l also appear. To play the selected source using a Surround mode, refer to pages 49 to 53. Check that the VIDEO-7 IN/OUT switch is set to IN when using the component connected to the VIDEO-7 connectors. Refer to the procedure on the following page to select the source using the on-screen display. 4. Select the INPUT mode. (Only an analog signal is output when AM, FM, PHONO and TAPE-2 is selected.) When the CD player, DAT deck or other component is connected to a DIGITAL INPUT OPT-1, OPT-2 or COAXIAL connector, you can use the INPUT MODE button on the main unit to choose whether the signal from that component will be digital or analog. o 3 QO , 0 DIGITAL ANALOG AC-3 RF OPTICAL COAXIAL The indicator corresponding to the selected INPUT mode lights up. • If the input signal is not digital, the TX-DS939 automatically switches to analog playback. However, for optimum results with an analog input signal, the INPUT mode should be set to ANALOG. • The TX-DS939 is equipped with a high-precision microcomputer. Therefore, if external noise interferes with this unit's signal, use a commercially available adaptor with a built-in noise filter. Once the INPUT mode of a component is set to DIGITAL, that setting will automatically be selected each time the input selector button for that component is pressed to choose it as the source. To select a different component as the digital source: 1. Press the input selector button for the component that is currently set as the digital source. 2. Press the INPUT MODE button to select ANALOG. 3. Press the input selector button for the different component that will be set as the digital source, and then press the INPUT MODE button to select the desired digital setting. 5. Follow the operating instructions for the selected unit to start playback. Refer to Tuning in a radio station on page 38 for more details on using the tuner. 6. Adjust the volume to the appropriate level using the MASTER VOLUME control knob. The tone control can be adjusted using the on-screen display or main unit. Refer to Using the tone control on page 54 for more details. 36