Onkyo TX-DS939 Owner Manual - Page 32

Setting up the speaker systems C:01,XE,r.O. 1 ** System Setup A ** ESC Speaker Setup Analyzer Setup R Speaker Distance 2 Level Calibration n Bass Peak Lvl Setup n 2 01 , 7-1.".2, 0 S * Analyzer Setup :I< ESC 1 .Connect Microphone To Analyzer Input Behind Front Panel 4 2 .Place Microphone In Your Primary Listening Position. , Press ENTER. Es 4 * Analyzer Setup Time Left 1 :23 ( For Best Results , ) ( Please Be Quiet . ) Interrupt? En 3 01,1,1,0 * Analyzer Setup Completed! S 01 , 71.-SIC:1 * Analyzer Setup ESC microphone and or Speakers are not connected correctly Check their connections I Please Try Again 32 On-screen display operation 1. Move the cursor to Analyzer Setup in the System Setup A screen, and then press the Ow cursor button on the remote controller to display the Analyzer Setup screen. If an active subwoofer is connected, turn its power on and set its level to the center position. 2. Position the cursor over i= and press the ENTER button. The MASTER VOLUME automatically increases to the standard level. The noise level of the room is measured for approximately ten seconds, then a test signal sounds and the parameters are automatically adjusted. If the test signal does not sound, there is too much noise in the room. In order for the Analyzer Setup to be performed correctly, be sure that there is no noise in the room. Remain quiet and turn off noisy appliances, such as the air conditioner. While the Analyzer Setup is being performed, a screen appears showing the amount of time remaining until the procedure is finished. Try to stay as quiet as possible until the Analyzer Setup procedure is finished. Stopping the Analyzer Setup Position the cursor over (Interrupt?) and press the ENTER button. (Refer to Restarting the Analyzer Setup below for the restarting procedure.) 3. If the Analyzer Setup is completed correctly, "Completed!" appears on the screen. If "Microphone and/or Speakers are not connected correctly. Check their connections." appears on the screen, check for the following possible causes, then try performing the Analyzer Setup procedure again. • The microphone and/or the speakers are not connected correctly. The battery is not installed in the microphone. • The microphone is not set to ON. • The subwoofer parameter of Speaker Setup is set incorrectly. Restarting the Analyzer Setup Press the Pilw button. NOTE: • Since the speaker distance is determined by the length of time needed for the sound wave to reach the microphone, the measured speaker distances may differ from the actual ones depending on the speaker type and position. If the speaker distances cannot be set correctly even after performing the procedure a few times, the speaker distances should be set manually. (Refer to System Setup screen on page 34 for more details.) • If there are large differences in the speaker distances, the TX-DS939 will automatically adjust them.