Onkyo TX-DS939 Owner Manual - Page 23

Setting up the Multi-Room Remote System Xantech Multi-Room System (U.S. and Canadian models): NOTE: • Do not plug in the power cord until all connections have been made. Make connections through Ls, as shown in the connection diagram at the bottom of the page. Be sure the components are correctly connected. ■ Connecting components equipped with Onkyo RI connectors MAIN ROOM SUB ROOM 1. Onkyo components (a) Speaker (Main room) TX-DS939 \ Speaker (Main room) 5. Connecting block Remote --control 6. Remote Sensor \ Power supply 2. Power amplifier 3. Speaker rocrI) [x4.TV 3. Speaker rnnml N 1. Set up the Onkyo RI components (a). 2. Connect the TX-DS939 to the power amplifier. ((I) 3. Connect the sub-room speaker cables to the speaker terminals on the power amplifier. (,2j) 4. Connect the TX-DS939 to the TV. ( 5. Install the Connecting Block in the main room, then connect it to the TX-DS939. 6. Install the Remote Sensor in the subroom, then connect it to the Connecting Block in the main room. (6) • Connecting components not equipped with Onkyo RI connectors 3. Emitter (1 (c) MAIN ROOM 5. Emitted. (e) SUB ROOM 4. Components(d) TX-DS939 Connecting block 1. Components(b)< ,z Speaker Speaker < (Main room) (Main room) , \ N Power , supply n Power amplifier Rem- ote control Remote Sensor Speaker (Sub room) 1TV Speaker (Sub room) 1. Connect the components (b) to the TX-DS939. 2. Make the connections described above in steps 2 through 6. 3. Install Emitter (c) so that its sensor is directed toward the components, then connect it to the TX-DS939. ( 6 ) To operate components positioned out of range of the emitter installed as described above: 4. Connect these components (d) to the TX-DS939. 5. Install another Emitter (e) so that its sensor is directed toward these components, then connect it to the Connecting Block. (1,) Connection diagram Power Amplifier Main IN O -OO- SPEAKERS •VIIE Monitor TV CI o MULTI SOURCE PRE OUT 0001 Gray Terminal MRx IN I OUT cci zefOca ITCAttle) FRONT SPEAKERS A O Speaker (Main Room) •• Speaker (Sub Room) Remote Sensor SUB ROOM Emitte Power supply I I Connecting block 23