Onkyo TX-DS939 Owner Manual - Page 7
Onkyo TX-DS939 Manual
View all Onkyo TX-DS939 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Control positions and names C) PHONES (headphone) jack [37] C) MR OFF (Multi-Room Remote System on/off) indicator [24] C) STAND-BY/RECEIVED indicator [19] The STAND-BY/RECEIVED indicator lights up each time a signal is received from the remote controller . ® POWER switch and POWER indicator (SYSTEM switch and SYSTEM indicator on the European/Australian model) [19] C) Remote controller sensor C) Dolby Digital (AC-3) indicator [49] © Upper display ® Input selector buttons [36, 44-48] Video: VIDEO-1, VIDEO-2, VIDEO-3, VIDEO-4, VIDEO-5, VIDEO-6, VIDEO-7 Audio: TAPE-1, TAPE-2 MONITOR, FM, AM, PHONO, CD ® MASTER VOLUME control knob and indicator [33, 36] Correctly calibrated, the 0 dB position corresponds to the volume level in a film mixing room during the production of a soundtrack. The MASTER VOLUME control knob simultaneously adjusts the volume of the front, center and Surround speakers and the PRE OUT outputs (hut not the multi-source output). Turning it clockvise increases the volume. The volume can also be adjusted using the remote controller 's VOL A/V buttons. The Master Volume level settings shown on the display are: -.0 dB (minimum), -60 - -1, 0, +1 - +18 dB (maximum). Depending on the calibration, it may be impossible to set the MASTER VOLUME level to +18dB. Even if the knob is manually turned to its maximum, it will return to its highest possible setting. Use the remote controller to adjust the multi-source level. C) DOOR OPEN button Press to open the front panel. C) MR OFF (Multi-Room Remote System on/off) button [24] © SPEAKERS A/B selector buttons [36] Used to select the speakers. The indicator in the display for the selected speakers lights up. Speakers A and B can not be selected at the same time. C) GROUP button [39-40] 3 SCAN button [40, 42] (15) nIRFeri TUNING huttnn [38] 8 1 - 9 and 0/10 buttons [38-40, 43] ® Lower display © TUNING , P. buttons [38, 42-43, 46] C) ANALYZER microphone connector [31] O MEMORY button [39] • FM MUTE/MODE button [38, 39, 43] 0 VIDEO-7 connectors and OUT/IN switch [14] • REC OUT (record out) button [44-45] 0 MULTI SOURCE (multi-source) button [24] 3 CHARACTER button [43] e DISPLAY button [42] © SURROUND MODE buttons [49] OFF: Switches between the stereo and Surround modes. .11/110-: Used to select the desired Surround mode. DOLBY SURROUND: Used to select the Dolby digital (AC-3) or PRO LOGIC Surround mode. THX CINEMA, ACTION, DRAMA and MUSICAL: Used to select the desired Dolby digital (AC-3) or PRO LOGIC Surround mode. 3 DIMMER button (U.S./Canadian models only) Used to change the brightness of the display in four steps (bright, medium, dim and off). If a function is set with the display turned off, the display will light up for a few seconds, and then go off. PTY/TP (program type/traffic program) button [42] (European/Australian and Asian models only) O PARAMETER buttons [30, 33, 35, 49] OD INPUT MODE button [36] ® MIDNIGHT THEATER button [53] 7