Onkyo TX-NR5010 Owner Manual - Page 14
En-14, Attaching the Speaker Cable Labels, Speaker Connection Precautions
View all Onkyo TX-NR5010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
■ 11.2-channel playback By using a combination of the built-in power amplifier for 9-channel and an external power amplifier for 2-channel, you can enjoy up to 11.2-channel playback. Connect the external power amplifier's analog audio input jacks to FRONT WIDE PRE OUT of the AV receiver with audio cables. To perform the 11.2-channel playback, set the "11ch Playback" setting to "Yes" (➔ page 66). Power amplifier Attaching the Speaker Cable Labels The speaker terminals are color-coded for identification purpose. Speaker Front left, Front high left, Front wide left, Zone 2 left, Zone 3 left Front right, Front high right, Front wide right, Zone 2 right, Zone 3 right Center Surround left Surround right Surround back left Surround back right Color White Red Green Blue Gray Brown Tan The supplied speaker cable labels are also color-coded and you should attach them to the positive (+) side of each speaker cable in accordance with the table above. Then all you need to do is to match the color of each label to the corresponding speaker terminal. Front wide right Front wide left Note • If the "11ch Playback" setting is set to "Yes", no sound is output from the FRONT WIDE terminals. Connections Speaker Connection Precautions Read the following before connecting your speakers: • You can connect speakers with an impedance of between 4 and 16 ohms. If the impedance of any of the connected speakers is 4 ohms or more, but less than 6 ohms, be sure to set the minimum speaker impedance to "4ohms" (➔ page 66). If you use speakers with a lower impedance, and use the amplifier at high volume levels for a long period of time, the built-in protection circuit may be activated. • Disconnect the power cord from the wall outlet before making any connections. • Read the instructions supplied with your speakers. • Pay close attention to speaker wiring polarity. In other words, connect positive (+) terminals only to positive (+) terminals, and negative (-) terminals only to negative (-) terminals. If you get them the wrong way around, the sound will be out of phase and will sound unnatural. • Unnecessarily long, or very thin speaker cables may affect the sound quality and should be avoided. • Be careful not to short the positive and negative wires. Doing so may damage the AV receiver. • Make sure the metal core of the wire does not have contact with the AV receiver's rear panel. Doing so may damage the AV receiver. En-14