Onkyo TX-NR5010 Owner Manual - Page 43
En-43, Audyssey MultEQ XT32 Full Calibration,
View all Onkyo TX-NR5010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
1 Turn on the AV receiver and the connected TV. On the TV, select the input to which the AV receiver is connected. 2 Set the speaker setup microphone at the Main Listening Position B, and connect it to the SETUP MIC jack. SETUP MIC jack Speaker setup microphone The speaker setting menu appears. Note • The on-screen menus appear only on a TV that is connected to HDMI OUT MAIN. If your TV is connected to other video outputs, use the AV receiver's display when changing settings. 3 When you've finished making the settings, press ENTER. MultEQ XT32: Auto Setup Speakers Type(Front A) Speakers Type(Front B) Powered Zone 2 Powered Zone 3 11ch Playback Subwoofer AUDYSSEY Normal No No No No 2ch Perform the "Speaker Setup" according to your speaker configuration: - Speakers Type(Front A) (➔ page 66) - Speakers Type(Front B) (➔ page 66) - Powered Zone 2 (➔ page 66) - Powered Zone 3 (➔ page 66) - 11ch Playback (➔ page 66) - Subwoofer (➔ page 67) If you use a powered subwoofer(s), go to step 4. If not, go to step 5. If "Speakers Type(Front A)" or "Speakers Type(Front B)" is set to "Digital Crossover", a confirmation screen appears. Select "Next (2-7. Digital Processing Crossover Network)" to display the screen for Digital Processing Crossover Network (➔ page 71). Continue with the settings. 4 Adjust the subwoofer volume level to 75 dB, and then press ENTER. Test tones are played through the subwoofer. Use the volume control on the subwoofer. When the "Subwoofer" setting is set to "1ch" only, the left-hand subwoofer (SW1) will be measured. When the "Subwoofer" setting is set to "1ch" with two subwoofers connected, the right-hand subwoofer (SW2) will not be measured and no sound will be output. An error will occur if you set "Subwoofer" to "2ch" without connecting any subwoofers, or with only one subwoofer connected. Note • If your subwoofer does not have a volume control, disregard the displayed level and press ENTER to proceed to the next step. • If you set the subwoofer's volume control to its maximum and the level displayed is lower than 75 dB, leave the subwoofer's volume control at its maximum and press ENTER to proceed to the next step. • If you use two subwoofers, perform this step twice. 5 Use R/X to select "Audyssey Quick Start" or "Audyssey MultEQ XT32 Full Calibration", and then press ENTER. Turning On & Basic Operations 6 Press ENTER. Audyssey MultEQ® XT32 Room Correction and Speaker Setup starts. Test tones are played through each speaker as Audyssey MultEQ XT32 Room Correction and Speaker Setup runs. This process takes a few minutes. Please refrain from talking during measurements and do not stand between speakers and the microphone. Do not disconnect the speaker setup microphone during Audyssey MultEQ XT32 Room Correction and Speaker Setup, unless you want to cancel the setup. If you select "Audyssey Quick Start", you will go to step 9. 7 Place the speaker setup microphone at the next position, and then press ENTER. Audyssey MultEQ XT32 performs more measurements. This takes a few minutes. 8 When prompted, repeat step 7. To be continued En-43