Onkyo TX-NR636 User Manual - Page 46
Connecting and Operating Onkyo RI Components, About RI Function, RI Connection and Setting
View all Onkyo TX-NR636 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Connecting and Operating Onkyo RI Components RI Connection and Setting Connecting and Operating Onkyo RI Components • The RCV, ZONE2, and TV buttons cannot be programmed. About RI Function Connecting an Onkyo component with RI jack such as the separately sold RI Dock to the unit by using an RI cable and an analog audio (RCA) cable enables the following RI functions: System On / Auto Power On: Starting playback on a component connected via RI when the unit is on standby mode, automatically turns on the unit to select the relevant component as its input source. Direct Change: When playback is started on a component connected via RI, the unit selects that component as the input source. Remote Controller Operation: Allows you to operate RIcompatible Onkyo components using the AV receiver's remote controller. Point the remote controller at remote control sensor of the unit. This operation is possible only when the RI remote control code is programmed. • Some components may not support all RI functions. • These functions do not work when Zone 2 is turned on. • For information on the RI functions, also refer to each component's instruction manual. L R Connect an Onkyo component with RI jack to this unit using an RI cable and an analog audio (RCA) cable. For details, refer to the instruction manual of the component with RI jack. The RI cable can be connected in any order. When there are two RI jacks, both jacks work in the same way and are interchangeable. To connect the RI Dock or cassette tape deck via RI, you must: Rename the input selector To make the RI functions work, you must rename the input selectors on the unit. Press TV/CD or GAME to display "TV/CD" or "GAME" on the main unit display. Then press and hold TV/CD or GAME 3 seconds or more to switch the display to "DOCK" or "TAPE". Program the RI remote control code Program the remote control code to any REMOTE MODE button on the remote controller. This will allow you to operate the component by pointing the remote controller at the unit instead of the component. 1. Press DISPLAY for 3 or more seconds while holding down the REMOTE MODE button to which you want to program the remote control code. • The remote indicator will light. 2. With the number buttons, enter the following 5-digit remote control code within 30 seconds. RI Dock: 81993 Cassette tape deck with RI jack: 42157 • Programming is complete when the remote indicator flashes twice. The remote indicator flashes once slowly when programming the remote control code fails. Try again. Change the input selector on the RI Dock to "HDD" or "HDD/DOC". For details, refer to the RI Dock's instruction manual. To operate Onkyo components directly or Onkyo components that are not connected via RI, use the following remote control codes: Onkyo DVD player: 30627 Onkyo CD player: 71817 RI Dock: 82990 • With some models, operation may be not possible in part or not possible at all. 46