Onkyo TX-NR636 User Manual - Page 49
Updating the Firmware via USB, Error Code, Others, Before Start - firmware update
View all Onkyo TX-NR636 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
If an Error Message is Displayed Case 1: When an error occurs Error!" is appeared on the display of the unit. ("" represents an alphanumeric character.) Check the following: Error Code • -01, -10: Ethernet cable not found. Connect the Ethernet cable properly. • -02, -03, -04, -05, -06, -11, -13, -14, -16, -17, -18, -20, -21: Internet connection error. Check the following: - Whether the router is turned on - Whether this unit and router are connected to the network Try to disconnect and then connect again the power to the unit and router. This may solve the problem. If you are still unable to connect to the Internet, the DNS server or proxy server may be temporarily down. Check the service status with your ISP provider. • Others: disconnect then reconnect the AC power cord, from the beginning. Updating the Firmware via USB Before Start: • Prepare a 64 MB or larger USB storage device. - Media inserted in a USB card reader may not be used for this function. - USB storage devices with security function are not supported. - USB hubs and USB devices with hub function are not supported. Do not connect these devices to the unit. • Delete any data stored on the USB storage device. • Turn off the controller component (PC etc.) connected to the network. • Stop any playing Internet radio, USB storage device, or server content. • If Zone 2 is active, press OFF on the unit to turn it off. • If "HDMI CEC (RIHD)" is set to "On", set it to "Off" (default value). - After pressing RCV, press HOME on the remote controller. Select "Setup" with the cursors and press ENTER. Then, after selecting "7.Hardware Setup" - "HDMI" and pressing ENTER, select "HDMI CEC (RIHD)" to select "Off". ½½Some USB storage devices may take long to load, may not be loaded correctly, or may not be correctly fed depending on the device or their content. ½½Onkyo will not be liable whatsoever for any loss or damage of data, or storage failure arising from the use of the USB storage device with this AV receiver. Thank you for your understanding. ½½The description may differ from the on-screen display but that will not change the way to operate or the function. Firmware Update Update 1. Connect the USB storage device to your PC. 2. Download the firmware file from the Onkyo website to your PC and unzip. Firmware files are named in the following way: ONKAVR zip Unzip the file on your PC. The number of unzipped files and folders varies depending on the model. 3. Copy all unzipped files and folders to the root folder of the USB storage device. • Make sure to copy the unzipped files. 4. Press USB on the remote controller to select "USB". 5. Connect the USB storage device to the USB port of the unit. • If you connect a USB hard disk drive to the USB port of the unit, we recommend that you use its AC adapter to power it. • If the USB storage device has been partitioned, each section will be treated as an independent device. 49