Onkyo TX SR806 Owner Manual - Page 104
Using the Remote Controller in Zone 2 and Multiroom Control Kits, Using a Multiroom Kit with Zone 2
UPC - 751398008238
View all Onkyo TX SR806 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Zone 2-Continued Using the Remote Controller in Zone 2 and Multiroom Control Kits To control the AV receiver/AV amplifier with the remote controller while you're in the Zone 2 room, you'll need a commercially available multiroom remote control kit. • Multiroom kits are made by Niles and Xantech. These kits can also be used when there isn't a clear line of sight to the AV receiver/AV amplifier's remote sensor, such as when it's installed inside a cabinet. Using a Multiroom Kit with Zone 2 In this setup, the IR receiver in Zone 2 picks up the infrared signals from the remote controller and feeds them through to the AV receiver/AV amplifier in the main room via the connecting block. IR IN Connecting block IR receiver Remote controller Main room Zone 2 Signal flow The miniplug cable from the connecting block should be connected to the AV receiver/AV amplifier's IR IN jack, as shown below. From the connecting block Miniplug cable Using a Multiroom Kit with a Cabinet In this setup, the IR receiver picks up the infrared signals from the remote controller and feeds them to the AV receiver/AV amplifier located in the cabinet via the connecting block. IR IN Connecting block IR receiver Inside cabinet Signal flow Remote controller Using a Multiroom Kit with Other Components In this setup, an IR emitter is connected to the AV receiver/AV amplifier's IR OUT jack and placed in front of the other component's remote control sensor. Infrared signals received at the AV receiver/AV amplifier's IR IN jack are fed through to the other component via the IR emitter. Signals picked up by the AV receiver/AV amplifier's remote control sensor are not output. IR IN IR OUT Connecting block AV receiver/ AV amplifier IR Emitter IR receiver Remote controller Other component AV receiver/AV amplifier Signal flow The IR emitter should be connected to the AV receiver/ AV amplifier's IR OUT jack, as shown below. 104 Miniplug cable Other component Miniplug AV receiver/AV amplifier Signal flow Emitter IR Emitter Remote controller sensor