Onkyo TX-SV525 Owner Manual - Page 5

Before using this unit (Worldwide models only) • ,000000 0OA00u00zz00ia00m00u00rt00000000 awos. 00 Go 0 0 o 0 00 0 00000000000 00000000000 00 uu 00 VOLTAGE SELECTOR AM FREQ. STEP 9kHz 10kHz -I IE I Setting the Voltage selector I. Determine the proper voltage for your area: 220V or 120V. 2. If the preset voltage is not correct for your area, insert a screw- driver into the groove in the switch. Slide the switch all the way to the right (120V) or to the left (220V), whichever is appropriate. Setting the tuning step frequency Worldwide models are equipped with a switch that controls the AM (9kHz/10kHz) band tuning steps. Please set this switch to match the tuning step frequency in your area. U.S.A.: AM 10kHz Other areas: AM 9kHz Insert the batteries into the remote control according to the illustration. Remote control sensor TX-SV525/R -3 3 approx. 5m r Using the remote control The following information will help you get optimal use from the remote control. • Place this unit away from direct bright light, which can prevent proper operation of the remote control. • Make sure audio rack doors do not have tinted glass. If this unit is placed behind such a door, this may prevent proper remote control operation. • Using other remote controls in the same room as this unit's remote control may cause interference. Regarding the WI** Average battery life is about one year, depending upon the frequency of use and the environment (temperature and humidity) in which the remote control is used. Only use batteries of the kind specified in the table below. Type Manganese Voltage I.5V Size AA. R6 or UM-3 Warning • Do not leave an expired battery in the case - it may leak or dam- age the remote control. • Do not use nickel cadmium (rechargeable) batteries. • Replace both batteries at once; do not use one old battery and one new battery. L 5