Onkyo TX-SV535 Owner Manual - Page 14

Connection for Multiple-Room Remote Control U.S.A. and Canadian models (Xantech Multiple-Room systems) Do not plug in the power cord until all connections have been [node. When making connections i, through 5 , he sure to connect the units as shown in the connection diagram below. Do not make a mistake when connecting the units. A. Operating components displaying Onkyo's RI mark from the sub-room Components mounted in a rack should he c mected as shown below to enable remote control operation. MAIN ROOM SUB ROOM 1. Onkyo components (a) Speaker A (Main room) TX-SV535 Speaker A (Main room) 3. Connecting block - Power supply Remote ,-.control 4. Dinky Link or J-Box Receiver 2. Speaker B I (Sub room) \\, 2. Speaker B (Sub room) 1. Set up the components (a) displaying Onkyo's R I mark. 2. Connect the speaker B cables to the speaker terminal on the TX-SV535. ( 3. Install Connecting Block 789-40 in the main room, then connect it to the TXSV535. (:2,) (Connect Power Supply 781C-00 or 782-00 to the Connecting Block.) 4. Install Xantech's .1-Box Receiver 78010 or Dinky Link 480B-00 in the subroom, then connect it to the Connecting Block in the main room. ( 3 ) B. Using a remote control to operate components not displaying Onkyo's RI mark from the sub-room 3. Emitter 0 (c) MAIN ROOM 5. Emitter (e) 4. Components(d) TX-SV535 Connecting block 1. Components(b) Speake (Main room) Speaker (Main room) Power supply SUB ROOM r -Remote ,control Dinky Link or -J-Box Receiver \. Speaker r rSpeaker (Sub room) ' (Sub room) ' v 1 I. Connect the components (b) to the TX-SV535. 2. Make the connections described above in steps 2 through 4 of section A. 3. Install Emitter 282-00 (c) so that its sensor is directed toward these components. then connect it to the TXSV535. ( 4 ) • Operating components which are positioned out of the range of the emitter installed as described above 4. Connect the components (d) to the TX-SV535. S. Install another Emitter 282-00 (e) so that its sensor is directed toward these components, then connect it to the Connecting Block 789-40. ( _5,) Connection diagram Speaker A Main Room) Connecting block 789-40, Emitter 282-00 O 5 14 t _J o FRONT SPEAKERS co 00 C O (REMOTE ) c o o O. TX-SV535 MRx IN 61 OUT Gray Terminal FRONT SPEAKERS MAIN 0 Power supply 781C-00 or Speaker B (Sub Room) Dinky link 480B-00 or J-Box Receiver 780-10 SUB ROOM