Onkyo TX-SV535 Owner Manual - Page 20

Using the tuner Please make sure that the TAPE-2 MONITOR indicator is off and audio muting is off. 2 I l i ' 0,0-1- If i t-' 0 0 I= I1 I 0 000 FM MUTE/MODE 1 Tuning the ratheManual tuning and Direct tuning) When the frequency is not known-Manual tuning I. Press the FM or AM button. 2. Use the t DOWN TUNING UP ► buttons to change the fre- quency. UP the frequency increases. DOWN the frequency decreases. 2 • The frequency is changed in 50 kHz steps in FM and I() kHz (or 9kHzi in AM when the tuning selector button is pressed in single steps. • If this button is held continuously for more than (1.5 seconds, the frequencies are scanned automatically. (FM auto tuning mode) When a broadcast is received, scanning stops. DE' 1 t a if When the frequency is known-Direct tuning . Press the FM or AM button. . Press the DIRECT TUNING button. The "-- will flash 16 seconds in the frequency display. Enter the frequency with the number buttons while the cursor are flashing. Example: 88. 10 MHz 8 K (1/1(1 • When receiving AM broadcasts with a 9 kHz step (this depending on your region), you can enter the frequency directly. • With I() kHz steps. entering a number for the f0 kHz digit will set the I kHz digit automatically to 0. • If you enter a frequency that does not have a station, this unit will automatically tune to the next station immediately below that sta- tion. • If you enter a frequency that is out of range, this unit will return to the previous frequency. If this happens, repeat the procedure. FM MOE MODE FM MUTE > OFF Listening to a stereo radio stations (FM only) If y ou tune in a stereo FM station, the STEREO indicator will he illuminated if the signal is sufficiently strong. If the signal is weak, it may he impossible to tune in to your desired station. In this case, tune in as follows. Press the FM MUTE/MODE button and FM MUTE OFF lights. At this time, the station will be in mono and interstation noise will he heard. Select the station you want listen to. 20