Onkyo TX-SV535 Owner Manual - Page 32

Specifications AMPLIFIER SECTION Power Output: Stero mode Front I./R channels 80 watts per channel min. RMS. at 8 ohms, both channels driven, from 20 Hz to 20,000 Hz, with no more than 0.08% total harmonic distortion. Continuous power output: 2 x 100 watts at 8 ohms (DIN) Surround mode and Multi source mode Front L/R and center channels 65 W + 65 W + 65 W (I kHz 0.08 % 8 ohms) Rear channels (Rear only driven) 25 Vv' + 25 W (1 kHz 0.8 'It 8 ohms) Remote channels FM Distortion: 65 W 65 W ( I kHz 01)8'4 8 ohms) 0.08% at rated power (FRONT) Damping Factor: 60 at 8 ohms i FRONT) Input sensitivities and impedance: Phono: 2.5 mV/51) kohms Output level and impedance: CD/Tape play/Video in: 150 mV/50 kohms Tape ree/Video out: 150 mV/2.2 kohms Phono Overload: Pre out (SUBWOOFERi: I V/2.2 kohms 120 my RMS. at 1.000 Hz, 0.5% THD. Frequency Response: 20 to 30.000 Ilz. +/-1 dB RIAA Deviation: 20 to 20,000 Hz. +1-0.8 dB Tone Control: BASS: 44-10 dB at 100 Hz Signal to Notse Ratio: TREBLE.: +1-I0 dB at 10.000 Hz PHONO: 80 dB IHF A. 5 inV input) CD/TAPE 100 dB (IHF AI Muting: 0,0 dB VIDEO SECTION Signal sensitivity and impedance: VDP/VCR input. output( I Vp-p. 75 ohms TUNER SECTION FM: Tuning Range: Usable Sensitivity: 50dB Quieting Sensitivity: Capture Ratio: Image Rejection Ratio: IF Rejection Ratio: Signal-to-Noise Ratio: 87.5 ---- 1084) MHz (50 kHz steps) Mono: 1 1.2 dBf. I .0 µV (75 ohms) 0.9 µV (26 dB S/N, 40 kHz Div.) 75 ohm DIN Stereo: 17.2 dBf. 2.0 µV (75 ohms) 23 tt V (46 dB S/N. 40 kHz Div.) 75 ohm DIN Mono: 17.2 dBf. 2.0 µV (75 ohms) Stereo: 37.2 d1.31, 20µV (75 ohms) 1 .5 dB USA & Canadian models: 40 dB Other area models: 85 dB 90 dB Mono: 73 dB Stereo: 67 dB Alternate Channel Attenuation: AM Suppression Ratio: Total Harmonic Distortion: Frequency Response: Stereo Separation: Muting Level: 55 dB. 50 dB (DIN) 50 dB Mono: 0.15% Stereo: 0.25% 30 -- 15,000 Hz +/-1 .5 dB 45 dB at I kHz/30 dB at 100 - 10,000 Hz 17.2 /BI, 20µV (75 ohms) AM: Tuning Range: Usable Sensitivity: Image Rejection Ratio: IF Rejection Ratio: Signal-to-Noise Ratio: Total Harmonic Distortion: European models 522 - 16I I kHz (9 kHz steps) USA & Canadian models 530 - 170) kHz (10 kHz steps) Worldwide models 531 --- 1602 kHz (9 kHz stops' 530- 1710 kHz (10 kHz steps) 30µV 40 dB 40 dB 40 dB 0.765 GENERAL Power Supply: Dimensions (W x H x Mass: USA & Canadian models AC 120 V. 60 Hz European models A('230 V. 50 Hz Worldwide models 120 and 220-230 V switchable, 50/60 Hz 455 x 170 x 389 min 17-15/16" x 6-1 1/16" x 15-5/16' 1 .8 kg (26.0 bit Specifications and features are subject to change without notice. This device employs a microcomputer to perform various functions and operations. If interference generated by an external power supply, radio waves, or other electrical source results in an accident which causes the specified operations and functions to operate abnormal ly. lei perform a reset. please follow the procedure below. I . Press and hold down the VIDEO-I button. then press the POWER button. 2. Aber "cleat' is displayed. the preset memory and each mode stored in the memory, such as surround, are initialized and will return lo the factory settings. SN 29342253Y ONKYO CORPORATION ONKYO CORPORATION Sales & Product Planning Div.: 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572, JAPAN Tel: 0720-31-8111 Fax: 0720-33-5222 ONKYO U.S.A. CORPORATION 200 Williams Drive, Ramsey, N.J. 07446, U.S.A. Tel: 201-825-7950 Fax: 201-825-8150 ONKYO EUROPE ELECTRONICS GmbH Industriestrasse 18-20, 82110 Germering, GERMANY Tel: 089 84 93 20 Fax: 089 84 93 226 ONKYO FRANCE Immeuble Le Diamant, Domaine Technologique de Saclay. 4 Rue Rene Razel. 91892 SACLAY, FRANCE Tel: (1) 69 33 14 00 Fax: (1) 69 41 35 84 107960