Optoma X313 User Manual - Page 47

Appendix

Get Optoma X313 PDF manuals and user guides View all Optoma X313 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 47 highlights

Appendix Installing the Dust Filter (Optional accessory) Be sure to follow the steps to install the dust filter. 1. Align the filter with these two hook positions (#1 & #2), then press it close to the projector from the left side to the right one. 2. Press the last hook position (#3) until it clicks. dust filter 1 23 3. Turn on the projector, then press "Menu", go to OPTIONS > Optional Filter > Optional Filter Installed and select "Yes". 4. Clean the dust filter periodically. The dust filter should be used in dusty environments only. Filters must be cleaned/replaced periodically i.e after every 500 hrs or 3 months, or sooner depending upon the air environment. Clogged filter can restrict air flow causing the projector to heat excessively leading to pre-mature lamp and/or projector failure. 5. To remove the dust filter, take it apart from the upper-left side of the hook position. 6. Turn on the projector, then press "Menu", go to OPTIONS > Optional Filter > Optional Filter Installed and select "No" when you pull out the dust filter and would not install it again. EN-47

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
EN-47
Appendix
Installing the Dust Filter (Optional
accessory)
Be sure to follow the steps to install the dust filter.
1.
Align the filter with these two hook positions (#1 & #2), then press it
close to the projector from the left side to the right one.
2.
Press the last hook position (#3) until it clicks.
3.
Turn on the projector, then press “Menu”, go to
OPTIONS > Optional Filter > Optional Filter Installed and
select “Yes”.
4.
Clean the dust filter periodically.
The dust filter should be used in dusty environments only. Filters
must be cleaned/replaced periodically i.e after every 500 hrs or 3
months, or sooner depending upon the air environment. Clogged
filter can restrict air flow causing the projector to heat excessively
leading to pre-mature lamp and/or projector failure.
5.
To remove the dust filter, take it apart from the upper-left side of the hook
position.
6.
Turn on the projector, then press “Menu”, go
to OPTIONS > Optional Filter > Optional
Filter Installed and select “No” when you pull
out the dust filter and would not install it
again.
1
2
3
dust filter