Panasonic AG DVC20 3 Ccd Dv Camcorder - Page 17
Selecting the remote control mode, Concerning the coin-type battery, Setting on the camera
UPC - 791871302958
View all Panasonic AG DVC20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Before using ª Selecting the remote control mode If 2 cameras are used simultaneously, set the mode for one pair of camera-recorder and remote control to [VCR1] and that of the other pair to [VCR2]. This will prevent interference between the 2 pairs. (The default setting is [VCR1]. When the coin-type battery is replaced, the setting will revert to the default [VCR1].) 1 Setting on the camera: Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2]. 2 Setting on the remote control: 2 STILL ADV PAUSE STILL ADV VOL STOP 1 VAR [VCR1]: Press [D] and [∫] simultaneously. 1 [VCR2]: Press [E] and [∫] simultaneously. 2 ª Concerning the coin-type battery ≥When the coin-type battery runs down, replace it with a new battery (part number: CR2025). The battery is normally expected to last about 1 year, but it depends on operation frequency. ≥Keep the coin-type battery out of the reach of children. ≥If the remote control mode of the camera and that of the remote control do not match with each other, "REMOTE" will appear. When the remote control is operated for the first time after the camera is turned on, "CHECK REMOTE MODE" (-33-) will appear and operation is impossible. Set the same remote control mode. ≥The remote control is intended for indoor operation. Outdoors or under strong light, the camera-recorder may not operate properly even within the usable ranges. ≥Within a 1 m (3 feet) range, you can operate the remote control from beside the remote control sensor (LCD monitor side) of the camera-recorder. 17