Panasonic AKHRP200 AKHRP200 User Guide - Page 10

Setup Mode Operations (continued) 5-1 Save ROP configuration file to memory card 1. Press to select [ND]. • Each press of toggles between [ND] (Save) and [CC] (load). ND CC SHT SYNC M.GAIN M.PED IRIS 2. Press or to select [y] and press to confirm the selection. • Do not remove a memory card that is being accessed. ND CC SHT SYNC M.GAIN M.PED IRIS • To cancel saving, select [n] and press . • The file is saved to the memory card and [Fin] appears when saving ends. • [E02] is displayed if the save operation to the memory card fails. (→page 13) If this happens, check the memory card and try again or insert another memory card to perform the operation again. • [E01] is displayed when an ROP configuration file with the same name as the one you are attempting to save already exists on the memory card. To overwrite the file, press or to select [y] and press .(→page 13) • For details on Save/Load data, refer to page 6. • To exit setup mode, hold down for about 2 seconds. • To make other settings, press to select a menu number. 5-2 Load ROP configuration file from memory card 1. Press to select [CC]. • Each press of toggles between [ND] (Save) and [CC] (load). ND CC SHT SYNC M.GAIN M.PED IRIS 2. Press or to select [y] and press to confirm the selection. • The file is loaded from the memory card and [Fin] appears when loading ends. A few seconds later, the unit is restarted. • Do not remove a memory card that is being accessed. ND CC SHT SYNC M.GAIN M.PED IRIS • To cancel loading, select [n] and press . • [E02] is displayed if the load operation from the memory card fails. (→page 13) If this happens, check the memory card and see whether the file exists on the memory card. If it does, start over from step 1. • To exit setup mode, hold down for about 2 seconds. 6 Format memory card 1. Press to select menu number [6]. Select y (Format)/n (Cancel) UP DATA SET ND CC M.GAIN SHT SYNC M.PED IRIS DOWN DISPLAY SELECT SET UP ND/CC M.GAIN/M.PED SHUTTER SHIFT + UP+DOWN SAVE/LOAD EXIT EXECUTE CAMERA 10-19 No. SELECT Press to confirm Press to exit setup mode (hold down) Press to select the menu number 2. Press or to select [y] and press to confirm the selection. • Card formatting starts. • Do not remove a memory card that is being accessed. ND CC SHT SYNC M.GAIN M.PED IRIS • To cancel formatting, select [n] and press . • When the formatting ends, [Fin] appears. • To exit setup mode, hold down for about 2 seconds. • To make other settings, press to select a menu number. 7 Select/set flare and pedestal Press to select menu number [7]. Select FL (Flare)/PE (Pedestal) UP DATA SET ND CC M.GAIN SHT SYNC M.PED IRIS DOWN SET UP DISPLAY SELECT ND/CC M.GAIN/M.PED SHUTTER SHIFT + UP+DOWN SAVE/LOAD EXIT EXECUTE CAMERA 10-19 No. SELECT Press to confirm Press to exit setup mode (hold down) Press to select the menu number 7-1 Set flare Press or to select [FL] and press to confirm the selection. ND CC SHT SYNC M.GAIN M.PED IRIS • To exit setup mode, hold down for about 2 seconds. • To make other settings, press to select a menu number. 10