Panasonic AKHRP200 AKHRP200 User Guide - Page 7

Setup Mode Operations Menu numbers 10 to 15 are for future use. 1. Set camera number 1. Open setup mode and check that menu number [1] is displayed. If a menu number other than [1] appears, press to select menu number [1]. Press to select the camera number UP ND CC SHT SYNC M.GAIN M.PED CAMERA 10-19 DATA SET IRIS DOWN DISPLAY SELECT SET UP ND/CC M.GAIN/M.PED SHUTTER SHIFT + UP+DOWN SAVE/LOAD EXIT EXECUTE No. SELECT Press to exit setup mode (hold down) Press to select the menu number Press to confirm the camera number 2. Press or to select a camera number and press to confirm the selection. ND CC SHT SYNC M.GAIN M.PED IRIS To select camera number 2 • Camera numbers become available after exiting setup mode. • To exit setup mode, hold down for about 2 seconds. • To make other settings, press to select a menu number. 2. Save scene file to/load scene file from memory card Current operating status data is saved as a scene file to the memory card. Press to select menu number [2]. Select file number, Select y (Select)/ Save file indication n (Cancel) Load file indication UP ND CC SHT SYNC M.GAIN M.PED CAMERA 10-19 DATA SET IRIS DOWN SET UP DISPLAY SELECT ND/CC M.GAIN/M.PED SHUTTER SHIFT + UP+DOWN SAVE/LOAD EXIT EXECUTE No. SELECT Press to save/load Press to confirm Press to exit setup mode (hold down) Press to select the menu number 2-1 Save scene file to memory card 1. Press to select [ND]. • Each press of toggles between [ND] (Save) and [CC] (load). ND CC SHT SYNC M.GAIN M.PED 2. Press or to select a file number on the memory card and press to confirm the selection. ND CC SHT SYNC M.GAIN M.PED IRIS To save a file to file no. 2 on the memory card 3. Press or to select [y] and press to confirm the selection. • Do not remove a memory card that is being accessed. ND CC SHT SYNC M.GAIN M.PED IRIS • To cancel saving, select [n] and press . • The file is saved to the memory card and [Fin] appears when saving ends. • [E02] is displayed if the save operation to the memory card fails. (→page 13) If this happens, check the memory card and try again or insert another memory card to perform the operation again. • [E01] is displayed when a scene file with the same name as the one you are attempting to save already exists on the memory card. To overwrite the file, press or to select [y] and press .(→page 13) • To exit setup mode, hold down for about 2 seconds. • To make other settings, press to select a menu number. 2-2 Load scene file from memory card Scene file data loaded from the memory card is returned to the operating status. (It is not returned to scene files 1 to 4. To return the data to scene files 1 to 4, exit setup mode and store the data in one of scene files 1 to 4. For details, refer to , the instruction manual.) 1. Press to select [CC]. • Each press of toggles between [ND] (Save) and [CC] (load). ND CC SHT SYNC M.GAIN M.PED IRIS 2. Press or to select a file number on the memory card and press to confirm the selection. ND CC SHT SYNC M.GAIN M.PED IRIS To load file no. 2 from the memory card 3. Press or to select [y] and press to confirm the selection. • Do not remove a memory card that is being accessed. ND CC SHT SYNC M.GAIN M.PED IRIS IRIS 7