Panasonic AW-UE100 IPSerial Control Interface Specifications - Page 11

5-3.Procedure of start/end of the update notifications reception To receive an update notification via IP, you must perform the update notification reception start process in advance. At a time like this, the number of the TCP port on the terminal for receiving the update notification (having the update notification sent) is specified. ① Update notification receive start step example）When reception is to be started with "192.168.0.10" used as the IP address of the camera http://192.168.0.10/cgi-bin/event?connect=start&my_port=31004&uid=0 ※ my_port ... Number of the TCP port on the terminal (any port) 【Update notification receive start sequence】 The update notification receive start command is sent from the terminal where the update notifications are to be received. "204 No Content" is returned from the camera which has received the command. PC(ROP) Camera http://192.168.0.10/cgi-bin/event?connect=start&my_port=31004&uid=0 204 No Content The port of PC1 where the update notifications are received is registered as port number 31004. 【Caution】 Proceed with the update notification receive start step when communication has been cut off because the LAN cable has been disconnected, for example. ② Update notification receive end step To close the application of the client, the update notification receive end step must be taken without fail. example) When reception is to be ended with "192.168.0.10" used as the IP address of the camera http://192.168.0.10/cgi-bin/event?connect=stop&my_port=31004&uid=0 ※ my_port ... Number of the TCP port on the terminal © Panasonic Corporation 2020 All Rights Reserved. 11