Panasonic AW-UE100 IPSerial Control Interface Specifications - Page 6

Communication method

Get Panasonic AW-UE100 PDF manuals and user guides View all Panasonic AW-UE100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

4.Communication method The camera can be controled by serial communication and IP communication respectively 4-1.Serial communication The camera communicates with RS422. The communication specifications are as follows Method Half Duplex Commnunication Speed 9600bps Data bit 8bit Stop bit 1bit Parity None Flow contorol None ▼Sequence of serial communication In case of Pan/Tilt Control command In case of Camera Control command PC(ROP) Camera PC(ROP) #P50 p50 DCB:1 ACK(0x06) DCB:1 Camera 【Restrictions】 1. When using the pan-tilt head control commands, send the commands with a gap of 40 ms between each command. Given below is the sequence. 2. Some settings and conditions may restrict the effects of other settings (※ including those with exclusive control conditions). See more detail in Capter 8 for the exclusive control conditions 3. Send the commands which change the settings only at the point in time when the changes are required. (Do not send them at regular intervals.) © Panasonic Corporation 2020 All Rights Reserved. 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
© Panasonic Corporation 2020 All Rights Reserved.
6
4.Communication method
The camera can be controled by serial communication and IP communication respectively
4-1.Serial communication
The camera communicates with RS422. The communication specifications are as follows
Method
Half Duplex
Commnunication Speed
9600bps
Data bit
8bit
Stop bit
1bit
Parity
None
Flow contorol
None
▼Sequence of serial communication
In case of Pan/Tilt Control command
In case of Camera Control command
【Restrictions】
1. When using the pan-tilt head control commands, send the commands with a gap of 40 ms between each command. Given below is the sequence.
2. Some settings and conditions may restrict the effects of other settings (※ including those with exclusive control conditions).
See more detail in Capter 8 for the exclusive control conditions
3. Send the commands which change the settings only at the point in time when the changes are required. (Do not send them at regular intervals.)
DCB:1
DCB:1
PC(ROP)
Camera
#P50
p50
PC(ROP)
Camera
ACK(0x06)