Panasonic DMR-E65S Dvd Recorder - Page 45

Convenient functions Channel/Clock settings when TV Guide On ScreenTM system is not used Refer to the control reference on page 42. Preparation: If the television program list has already been downloaded, return the unit to the factory preset condition using the steps indicated below. When the unit is on and stopped 1 Press and hold [X CH] and [W CH] on the main unit for about five seconds. The unit turns off. 2 Press [Í DVD POWER] to turn the unit on. 3 Complete the TV Guide On ScreenTM system setup (until [ENTER] is pressed after the "Watch TV" message screen is displayed). X CH W OPEN/CLOSE TIME SLIP DVD SD PC DRIVE SELECT TIME SLIP CH REC /x1.3 [Note] You can set timer recording only manually after you set the unit with "Auto Channel Setting". Auto channel/clock settings 1 Press [SETUP]. 2 Press [3, 4] to select "Channel" and press [1]. 3 Press [3, 4] to select "Auto Channel Setting" and press [ENTER]. 4 Press [2, 1] to select "Yes" and press [ENTER]. 5 Press [ENTER]. Auto Channel Setting starts. This takes a few minutes. The unit then proceeds with Auto Clock Setting. The time is displayed when finished. SETUP Auto Clock Setting Channel Auto Clock Setting is complete. Set Up Disc Video 4/4/2002 12:15 AM DST ON TIME ZONE.... CST Audio ≥DST, Daylight Saving Time, shows the summertime setting. ≥TIME ZONE shows the time difference from Greenwich meantime (GMT). EST (Eastern Standard Time) l GMT j5 CST (Central Standard Time) l GMT j6 MST (Mountain Standard Time) l GMT j7 PST (Pacific Standard Time) l GMT j8 AST (Alaska Standard Time) l GMT j9 HST (Hawaii Standard Time) l GMT j10 For other areas: xx hr ≥If the Auto Clock Setting does not start automatically, select "Auto Clock Setting" from the "Set Up" tab. ≥If the time was not set correctly, use manual clock setting (➡ page 11) or time zone adjust. 6 Press [ENTER]. ≥The unit configures channels according to the Antenna System settings as follows. Antenna system Band Channel VHF TV UHF 2-13 14-69 VHF 2-13 CATV LOW BAND 95-99 CATV MID/SUPER BAND 14-36 CATV CATV HYPER BAND 37-65 ULTRA BAND 66-94 100-125 SPECIAL CATV CHANNEL 1 Time Zone Adjust Adjust the time zone (j1 or i1) if it was not set correctly with auto clock setting. You cannot change this setting if you set the clock manually. 1 Press [SETUP]. 2 Press [3, 4] to select "Set Up" and press [1]. 3 Press [3, 4] to select "Time Zone Adjust" and press [ENTER]. SETUP Time Zone Adjust j1 Channel 0 Set Up i1 Disc Video 4 Press [3, 4] to select "s1" or "r1" and press [ENTER]. To exit the screen Press [SETUP]. To return to the previous screen Press [RETURN]. To cancel partway while Auto Channel/Clock Setting is taking place Press [RETURN]. RQT7303 45