Panasonic EP-MA70 Operating Instructions Multi-lingual - Page 16

Insert the tip of the fastening band into the hole.

Get Panasonic EP-MA70 PDF manuals and user guides View all Panasonic EP-MA70 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

English 6 Placing the controller 1 Placing the controller into the controller stand. 2 Fasten the controller cord using the clip. • Fasten so the cable under the clip will not sag too much with the backrest raised. (Because there is a chance of your legs, etc., getting caught) 1 2 When the controller stand is attached on the left side • Run the controller cord to the left. 1 Press the power. button on the controller to turn on the 2 Press button on the controller and hold until the legrest has risen far as it will go. • Continue pressing until a "beep-beep-beep" sound is heard. Legrest 2 3 Disconnect the controller cord. • Hook is released by pressing on the tab on the fastening band with your fingers. 4 Move the controller cord under the legrest to the left side. 5 Fasten the controller cord. • Press down from the edge if it does not fit in easily. 6 Insert the tip of the fastening band into the hole. • The controller cord is fastened to the right side prior to leaving the factory. Fastening band Fasten to the right side View from front Cord-Holder Groove 5 3 15 3 Tab Controller Cord 4 6 Controller Cord

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
15
English
6 Placing the controller
1
Placing the controller into the
controller stand.
2
Fasten the controller cord using
the clip.
• Fasten so the cable under the clip will not sag
too much with the backrest raised.
(Because there is a chance of your legs, etc.,
getting caught)
1
1
2
2
When the controller stand is attached on the left side
• Run the controller cord to the left.
1
Press the
button on the controller to turn on the
power.
2
Press
button on the controller and hold until
the legrest has risen far as it will go.
• Continue pressing until a “beep-beep-beep” sound is heard.
2
2
Legrest
3
Disconnect the controller cord.
• Hook is released by pressing on the tab on the fastening band with your fingers.
4
Move the controller cord under the legrest to the
left side.
5
Fasten the controller cord.
• Press down from the edge if it does not fit in easily.
6
Insert the tip of the fastening band into the hole.
• The controller cord is fastened to the right side prior to leaving the
factory.
5
5
6
Cord-Holder Groove
Controller Cord
3
3
4
Controller Cord
Fasten to the right side
Fastening band
Tab
View from front