Panasonic EP-MA70 Operating Instructions Multi-lingual - Page 22

Approximately 30 seconds after the body scanning starts, the massage heads slowly lower to

Page 22 highlights

English 1 Body scanning will commence when the program is selected. ( will flash.) • The body scanning will properly detect height ranges between approximately 55 and 72.8 in. (140 and 185 cm). Sit as far back in the seat as possible with your head on the pillow. The unit will automatically recline to the correct massage position. Correct Massage Position Reclined approx. 12° 1 2 3 4 Adjust the pillow height so that the bottom edge of the pillow is at ear level. See page 19. 1 NECK 2 SHOU LDER 3 MIDDLE BACK 4 LOWER BACK Raised approx. 55° • If the massage lounger is reclined further than the massage position angle, it will not automatically return to the correct massage position. 2 Approximately 30 seconds after the body scanning starts, the massage heads slowly lower to the shoulder position, and a soft tapping action begins to determine your shoulder position. Massage Head Tapping action • Airbags in the seat will inflate so the body will not shift during the body scanning. • Keep your head on the pillow until the soft tapping begins. Lifting your head from the pillow will result in incorrect determination of the shoulder position. 3 To adjust the shoulder position during the tapping action • When the shoulder position is incorrect, adjust the shoulder position while the soft tapping is in progress (for approximately 12 seconds), and use the POSITION button to move the massage heads up or down and then press button. A single press of the button will raise or lower the massage heads approximately 1/2 in. (1.2 cm). Too high Correct position of the massage head (The point where the tapping action should be felt.) Too low 4 Body scanning is completed when the tapping finishes. • If you press while the tapping action is still going on, it will end the body scanning and the massage will start. • The legrest adjusts automatically so that the soles of the feet touch the footrest wells according to your estimated height based on the shoulder position. • If the shoulder position is off drastically, turn the power off once, and repeat from Step 1 with your shoulder firmly pressed against the backrest. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47

21
English
1
Body scanning will commence when the program is selected. (
will flash.)
• The body scanning will properly detect height ranges between approximately 55 and 72.8 in. (140 and 185 cm).
1
2
3
4
Sit as far back in the seat as possible with
your head on the pillow.
Adjust the pillow height so that
the bottom edge of the pillow is
at ear level.
See page 19.
1
NECK
2
SHOU LDER
3
MIDDLE BACK
4
LOWER BACK
Correct Massage Position
The unit will automatically recline to the correct
massage position.
Raised
approx. 55°
Reclined
approx. 12°
• If the massage lounger is reclined further than the massage
position angle, it will not automatically return to the
correct massage position.
2
Approximately 30 seconds after the body scanning starts, the massage heads slowly lower to the shoulder
position, and a soft tapping action begins to determine your shoulder position.
Massage Head
Tapping
action
• Keep your head on the pillow until the soft tapping
begins. Lifting your head from the pillow will result in
incorrect determination of the shoulder position.
• Airbags in the seat will inflate so the body will not shift during
the body scanning.
3
To adjust the shoulder position during the tapping action
• When the shoulder position is incorrect, adjust the shoulder position while the soft tapping is in progress (for approximately
12 seconds), and use the POSITION button to move the massage heads up or down and then press
button.
A single press of the
button will raise or
lower the massage
heads
approximately
1/2 in. (1.2 cm).
Too low
Too high
Correct position of the
massage head
(The point where the
tapping action should be
felt.)
4
Body scanning is completed when the tapping finishes.
• If you press
while the tapping action is still going on, it will end the body scanning and the massage will start.
• The legrest adjusts automatically so that the soles of the feet touch the footrest wells according to your estimated height
based on the shoulder position.
• If the shoulder position is off
drastically, turn the power off
once, and repeat from Step 1 with your shoulder firmly pressed
against the backrest.