Panasonic HC-X1500 HC-X1500 Basic Operating Manual - Page 16
Treatment of clips
View all Panasonic HC-X1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Before using the unit ∫ LCD monitor and viewfinder ≥ Condensation sometimes forms on the LCD panel of the LCD monitor in locations subject to extreme temperature differences. If this happens, wipe with a soft, dry cloth. ≥ Do not touch the LCD monitor with your finger nails, or rub or press with strong force. ≥ The LCD monitor will be slightly darker than normal immediately after the power is turned on when the camera is very cold. It will return to its regular brightness when the internal temperature increases. ≥ The LCD monitor and viewfinder are managed with high precision so that at least 99.99% of the dots are effective pixels and 0.01% or less are invalid pixels and always lit. This is not a malfunction and it has no effect whatsoever on the recorded images. ≥ It may become difficult to see or difficult to recognize the touch when a LCD protection sheet is affixed. ∫ About Condensation (When the lens, the viewfinder or LCD Monitor is fogged up) Condensation occurs when there is a change in temperature or humidity, such as when the unit is taken from outside or a cold room to a warm room. Please be careful, as it may cause the lens, the viewfinder or LCD monitor to become soiled, moldy, or damaged. When taking the unit to a place which has a different temperature, if the unit is accustomed to the room temperature of the destination for about 1 hour, condensation can be prevented. (When the difference in temperature is severe, place the unit in a plastic bag or the like, remove air from the bag, and seal the bag.) When condensation has occurred, remove the battery and/or the AC adaptor and leave the unit like that for about 1 hour. When the unit becomes accustomed to the surrounding temperature, fogginess will disappear naturally. ∫ Caution regarding laser beams The MOS sensor may be damaged if the MOS sensor is subjected to light from a laser beam. Take sufficient care to prevent laser beams from striking the lens when shooting in an environment where laser devices are used. ∫ Treatment of clips Clips recorded with devices other than this unit are not supported by this unit. ∫ Regarding system frequencies You can change the system frequency (59.94 Hz/50.00 Hz) for this unit by using the menu. ≥ When AVCHD clips are recorded, it is not possible to use the same memory card with different system frequencies. When the system frequency is changed, use a different memory card. 16 DVQX2023 (ENG)