Panasonic LB60NTU Operating Instructions - Page 71
Others, Control commands, Cable specifications, Command, Remarks - pt projector lamp
UPC - 791871111260
View all Panasonic LB60NTU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Control commands The commands which the personal computer can use to control the projector are shown in the following table. Command Control Contents Remarks PON POF AVL IIS Q$S OSH Power ON Power OFF Volume Input signal selection Lamp ON condition query Shutter function In standby mode, all commands other than the PON command are ignored. B The PON command is ignored during lamp ON control. B If a PON command is received while the cooling fan is operating after the lamp has switched off, the lamp is not turned back on again straight away, in order to protect the lamp. Parameter 000-063 (Adjustment value 0-63) Parameter VID=VIDEO SVD=S-VIDEO RG1=PC1 RG2=PC2 NWP=WIRELESS (PT-LB60NTU only) Callback 0 = Standby 1 = Lamp ON control active 2 = Lamp ON 3 = Lamp OFF control active Operation will be switched between ON and OFF each time the command is sent. Do not switch operation ON and OFF after only short periods of time. If a command other than "OSH" is sent to the projector when the shutter function is used, the "ER401" command will be sent from the projector to the computer and the shutter function will be turned off. Cable specifications (When connected to a personal computer) At the projector 1 2 3 4 5 6 7 8 At the computer (DTE specifications) 7 8 3 5 2 6 1 4 9 ENGLISH-71 Others