Panasonic MX-ZX1800 MX-ZX1800 Owner s Manual - Page 6
Before Use - Disassembly and Assembly
View all Panasonic MX-ZX1800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Before Use - Disassembly and Assembly - Disassembly and assembly of the blender container base 1 Attach the container base holder while aligning the · marks on the container base and container base holder. Then turn it anticlockwise firmly. 1 Attach the container gasket into the groove on bottom of the blender container. (Failure to install the container gasket completely into the groove may lead to leaking liquids.) 2 Attach the container base holder while aligning the · mark on the blender container base and container base holder, then press the container base holder until you hear a click sound. 2 Pull out the container base holder. tDo not press tabs on the container base holder to avoid the blender container base falling. Tab (Both side) 3 Insert the blender container base into the blender container after aligning, then turn the container base holder clockwise until it stops turning. ( The "O" mark on the blender container base will align with the line on the blender container.) 3 Press tabs on the container base holder to release the blender container base from it. Tab (Both side) 4 Press tabs to remove the container base holder. Tab (Both side) CAUTION: µ Pay attention when handling the blender container base. Blades are sharp. µ If the gasket is not attached to blender container and/or the blender container base is not attached firmly onto the blender container, liquid may leak out. &/ Disassembly and assembly of the cover unit 1 Pull up the tab to open the cover. 1 Attach the cover gasket properly onto the cover groove, align the cover with the À mark on the cap. Then turn the cap clockwise until the À mark on the cover aligns well with the portion on the cap and you hear a click sound. (If the cover gasket is not properly installed, liquid may leak through the cover.) 2 Turn the cap anticlockwise and pull up to remove it. 2 Place the cover unit on the blender container and press down. CAUTION: µ When you force open the cover unit, be careful not to let any liquid splash. Additionally, take caution with the emerging steam, especially when blending hot liquids. CAUTION: µ Make sure the cover unit is attached firmly. Correct Incorrect µ When the tamper is not in use, make sure to attach the cap while blending. µ When using the "frozen" menu selection, insert the tamper from the cover opening instead of attaching the cap. Assembly of the ice pack and drip tray Use the ice pack tape strips to secure the ice pack over and under the blender container handle with the label facing the inner side of the pack. Set the drip tray onto the motor housing and push it down completely. CAUTION: When removing the drip tray after blending, beware of water spillage. &/ English