Panasonic PT47WXD63 PT47WXD63 User Guide - Page 10

ENGLISH OPTIONAL EQUIPMENT CONNECTIONS Digital Audio Out Connection Use the diagram below to connect the Digital Audio Output of your HDTV Projection Television to a Dolby Digital decoder. Digital Audio Out Dolby Digital 5.1 channel surround sound delivers digital-quality sound. Dolby Digital provides five discrete full-bandwidth channels for front left, front right, center, surround left and surround right, plus a LFE (Low Frequency Effect) subwoofer channel. For a full Home Theater sound experience, an external Dolby Digital decoder and a multichannel amplifier must be connected to the Digital Audio Out jack on the PTV. ANT A Cable In ANT B DCM INTERFACE HDMI SERVICE ONLY A/V IN TERMINALS ON BACK OF PROJECTION TELEVISION VIDEO Y PB S-VIDEO PR VIDEO L L DIGITAL AUDIO OUT L AUDIO IN R R 1 2 AUDIO COMPONENT VIDEO INPUT R INPUT INPUT INPUT PROG TO AUDIO 1 2 3 OUT AMP CABLES NOT SUPPLIED Six channel Speaker system Amplifier 90.7 MHZ OPTICAL IN Procedure • Connect the Digital Audio cable from the Digital Audio Out jack on the PTV to the Digital Audio In connection on the Dolby Digital decoder. Note: When ATSC channel is selected, the output from the Digital Audio Out jack will be Dolby Digital. But, if NTSC channel is selected, the output will be PCM. Program Out Connection (PROG OUT) You can connect a VCR to the PROG OUT terminal to record the program you are viewing on-screen. An external monitor can also be connected to the PROG OUT and TO AUDIO AMP terminals. Connect the VCR as shown below. ANT A Digital In ANT B DCM INTERFACE HDMI SERVICE ONLY A/V IN TERMINALS ON BACK OF PROJECTION TELEVISION VIDEO Y PB S-VIDEO PR VIDEO L L DIGITAL AUDIO OUT L AUDIO IN R R 1 2 AUDIO COMPONENT VIDEO INPUT INPUT 1 INPUT 2 R INPUT PROG TO AUDIO 3 OUT AMP CABLES NOT SUPPLIED VCR PLAY R E FF W STOP ANT OUT OUT VIDEO L - AUDIO - R IN ANT IN Procedure • Connect the VCR to PROG OUT and TO AUDIO AMP terminals • PROG OUT terminal display is the same as on-screen display. • See the VCR instruction manual for further instructions for recording the program. Notes: • This TV contains Video and Audio Outputs for the purpose of recording television programming to VCR. Due to license restrictions, if a device (STB, DVD, etc.) is connected to the HDMI input of the TV, no video or audio output is allowed. • Program Out signal may not be available when component input is selected for main picture. • Program Out signal is available when receiving digital channel. However, all digital formats are down converted to composite NTSC video. • When receiving digital or analog channels signals and the analog or digital CC is ON, Program Out connector will output open caption text in the NTSC video picture. If CC is OFF, only analog CC closed caption code is passed out the Program Out connector. • Certain program content output from the Program Out connector may have the Macrovision signal modification applied to its signal, preventing VCRs from recording this video signal. Amplifier Connection (Analog) To listen the audio through a separate stereo system, connect an external audio amplifier TO AUDIO AMP outputs on back of television. Note: TO AUDIO AMP terminals cannot be connected directly to external speakers. ANT A Cable In ANT B DCM INTERFACE HDMI SERVICE ONLY A/V IN TERMINALS ON BACK OF PROJECTION TELEVISION VIDEO Y PB S-VIDEO PR VIDEO L L DIGITAL AUDIO OUT L AUDIO IN R R 1 2 AUDIO COMPONENT VIDEO INPUT R INPUT INPUT INPUT PROG TO AUDIO 1 2 3 OUT AMP CABLES NOT SUPPLIED 90.7 MHZ Audio Adjustments • Select Speakers Off in Audio Other Adjust menu. • Set amplifier volume to the preferred level. 8 z