Panasonic SAAK960 Cd Stereo System - Page 16

ENGLISH DANSK External unit (continued) Connecting and playing a USB mass storage class device The USB connectivity enables you to connect and play MP3 tracks from USB mass storage class. Typically, USB memory devices. (Bulk only transfer) Preparation Before connecting any USB mass storage device to the unit, ensure that the data stored therein has been backed up. USB enabled device (not included) It is not recommended to use a USB extension cable. The device connected via the cable will not be recognised by this unit. 1 Reduce the volume and connect the USB mass storage device. 2 Press [6, USB] to start play. To pause play Action Press [6, USB]. Press again to resume play. stop play skip tracks Press [7, CLEAR]. "RESUME" is displayed. The position is memorized. Press [6, USB] to resume. Press [7, CLEAR] again to clear the position. Press [4, / REW] or [¢, / FF]. skip album Press [ALBUM ( or )] in the play mode. Press [ALBUM ( or )] once and then the numeric buttons in the stop mode. For other operating functions, they are similar as those described in "Discs" (\ page 8 ~ 10). Recording from a USB mass storage class device 1 Press [4, / REW ] or [¢, / FF] to select the desired track for recording. 2 Press [¶, REC] on the main unit to start recording. Compatible devices Devices which are defined as USB mass storage class: • USB devices that support bulk only transfer. • USB devices that support USB 2.0 full speed. Supported format Files must have the extension ".mp3" or ".MP3". Note: • CBI (Control/Bulk/Interrupt) is not supported. • A device using NTFS file system is not supported [Only FAT 12/16/32 (File Allocation Table 12/16/32) file system is supported]. • Depending on the sector size, some files may not work. • This unit can access up to 255 albums (including blank folders) and 2500 tracks. • The maximum number of tracks in a folder are 999 tracks. • Only one memory card will be selected when connecting a multiport USB card reader. Typically the first memory card inserted. • Disconnect the USB card reader from the unit when you remove the memory card. Failure to do so may cause malfunction to the device. • Compatible audio device will be charged when in USB mode. Avoid interfering with other Panasonic equipment Other Panasonic audio or video equipment may start functioning when you operate the unit using the supplied remote control. You can operate this unit in another mode by setting the remote control operating mode to "REMOTE 2". The main unit and remote control must be set to the same mode. 1 Press and hold [EXT-IN] on the main unit. Then press [2] on the remote control until "REMOTE 2" is displayed. 2 Press and hold [ENTER] on the remote control followed by numeric button [2]. To change the mode back to "REMOTE 1", repeat the steps above by replacing [2] with [1]. FRANÇAIS LANG - 4 LANG - 5 RQTX0169 16 RQT8043 RQTX0169-P.indd 16 7/18/08 9:25:08 AM