Panasonic SAAK960 Cd Stereo System - Page 6
Preparing the remote control, DEMO function
View all Panasonic SAAK960 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ENGLISH DANSK Getting started (continued) Optional antenna connections Use outdoor antenna if radio reception is poor. Note: Disconnect the outdoor antenna when the unit is not in use. Do not use the outdoor antenna during a lightning storm. FM outdoor antenna Rear panel of this unit FM outdoor antenna (not included) 75 Ω coaxial cable (not included) AM outdoor antenna Rear panel of this unit AM outdoor antenna (not included) 5-12 m (16-40 ft) • Disconnect the FM indoor antenna. • The antenna should be installed by a competent technician. AM loop antenna (included) • Run a piece of vinyl wire horizontally across a window or other convenient location. • Leave the loop antenna connected. Preparing the remote control AA/R6/LR6 ■ Batteries • Insert so the poles (+ and -) match those in the remote control. • Remove if the remote control is not going to be used for a long period of time. Store in a cool, dark place. • Do not use rechargeable type batteries. • Do not heat or expose to flame. • Do not leave the battery(ies) in an automobile exposed to direct sunlight for a long period of time with doors and windows closed. • Mishandling of batteries in the remote control can cause electrolyte leakage, which may cause a fire. Do not: • mix old and new batteries. • use different types of batteries at the same time. • take apart or short circuit; • attempt to recharge alkaline or manganese batteries. • use batteries if the covering has been peeled off. ■ Use Aim at the remote control sensor, avoiding obstacles, at a maximum range of 7 m (23 feet) directly in front of the unit. Refer to page 7 for the remote control sensor position. CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's instructions. FRANÇAIS LANG - 4 DEMO function LANG - 5 RQTX0169 6 RQT8043 7, STOP, -DEMO When the unit is first plugged in, a demonstration of its functions may be shown on the display. If the demo setting is off, you can show a demonstration by selecting "DEMO ON". Press and hold [7, STOP, - DEMO]. The display changes each time the button is held down. NO DEMO (off) Ô DEMO ON (on) While in standby mode, select "NO DEMO" to reduce power consumption. Note: DEMO function cannot be turned on when DIMMER is on. RQTX0169-P.indd 6 7/18/08 9:24:39 AM